5059 aluminium alloy


5059 is an aluminium alloy, primarily alloyed with magnesium. It is not strengthened by heat treatment, instead becoming stronger due to strain hardening, or cold mechanical working of the material.
Since heat treatment doesn't strongly affect the strength, 5059 can be readily welded and retain most of its mechanical strength.
5059 alloy was derived from closely related 5083 aluminium alloy by researchers at Corus Aluminum in 1999.

Basic properties

5059 has a density of, with a specific gravity of 2.66.
Melting point is.

Chemical properties

The alloy composition of 5059 is:
The mechanical properties of 5059 vary significantly with hardening and temperature.

–O hardening

Unhardened 5059 has a yield strength of and ultimate tensile strength of from. At cryogenic temperatures it is slightly stronger; above its strength is reduced.
Elongation, the strain before material failure, is 24% at room temperature.

–H131 hardening

yield strength of, ultimate tensile strength of.
Produced by Aleris under the AluStar brand.

–H136 hardening

yield strength of, ultimate tensile strength of.
Produced by Aleris under the AluStar brand.

–H321 hardening

H321 strain hardened 5059, with properties measured at, has yield strength of, ultimate tensile strength of, and elongation of 10%.

Uses

5059 has been used as a hull material for small aluminium boats or larger yachts. Its high strength and good corrosion resistance make it an excellent match for yachting.
5059 has been tested for use in vehicle armor.
5059 has been used for cryogenic propellant tanks for experimental reusable rocket vehicles.

Welding

5059 is often assembled using arc welding, typically MIG or TIG welding. The newer technique of Friction stir welding has also been successfully applied but is not in common use.
Arc welding reduces mechanical properties to no worse than –O hardening condition. The relatively low decrease in ultimate strength is extremely good performance for an aluminium alloy.