Soon after the introduction of the.308 Winchester-based wildcat.308×1.5" Barnes cartridge, wildcatters and experimenters began developing their own wildcats based on.308 Winchester. By 1963 there were several.22 and.24 caliber cartridges based on the Barnes’ cartridge. The new cartridges’ accuracy and efficiency was noticed by the bench rest shooting community. The.24 caliber cartridge version became known as the 6mm Bench Rest or the 6mm BR due to its widespread use in the sport of bench rest shooting. Because the cartridge was a wildcat and was not standardized until several years later, several variations of the cartridge existed. Cases required fire forming in the chamber as chambers of the rifles varied from one to another. Several 6mm BR variants exist apart from the Remington and Norma versions: the 6mm BRX, 6mm Dasher, 6 mm BRBS 6 mm UBL.
6mm BR Remington
In 1978 Remington started manufacturing their Remington 40-X rifle in the 6mm BR and named their version of the cartridge the 6mm Bench Rest Remington. By 1988 Remington was also manufacturing ammunition. Remington continues to offer the 6mm BR Remington in the 40-X series rifles. The Remington version of this cartridge is now considered to be obsolete.
6mm Norma BR
In 1996 Norma of Sweden introduced the 6mm Norma BR which was dimensionally similar to the 6mm BR Remington. However the chamber of the Norma version provided a longer throat making allowances for the seating of very low drag bullets. It was designed from the beginning to optimize accuracy, barrel life, and case capacity in a 6 mm cartridge for target shooting. As such it couples a sensible case volume to bore area ratio with ample space for loading relatively long slender projectiles that can provide good aerodynamic efficiency and external ballistic performance for the projectile diameter. This is the most common variation of the cartridge used today. The 6mm Norma BR has become a popular chambering in match rifles used in ISSF and CISM and other 300 metres rifle disciplines.
Design
The 6mm BR Remington cartridge is a.308×1.5" Barnes cartridge necked down to accommodate.243 bullets. The.308×1.5" Barnes cartridge is based on the.308 Winchester case shortened to. It is one of the earlier cartridges to follow the short, fat design concept. Short fat cartridges have characteristics that make them more efficient and accurate.
6mm Norma BR
The 6mm Norma BR cartridge was introduced by Norma in 1996. It is based on the 6mm BR Remington cartridge, although where Remington's cartridge was intended for bullets of about, Norma standardized their set of chambering specifications for a very low drag bullet of over, thus realizing the long-range capabilities of the cartridge. This required a much longer throat in rifles chambered for the Norma cartridge.
