The alto recorder in F, also known as a treble is a member of the recorder family. Up until the 17th century the alto instrument was normally in G4 instead of F4. The alto is between the soprano and tenor in size, and is correspondingly intermediate in pitch. It has the same general shape as a soprano, but is approximately 50% larger in all dimensions. A 50% increase in length causes a 50% increase in the wavelength for a given fingering. This lowers the pitch by a perfect fifth, that is from C to F. The F alto is a non-transposing instrument, though its basic scale is in F, that is, a fifthlower than the soprano recorder and a fourth higher than the tenor. So-called F fingerings are therefore used, as with the bassoon or the low register of the clarinet, in contrast to the C fingerings used for most other woodwinds. Its notation is usually at sounding pitch, but sometimes is written an octave lower than it sounds. Maintenance is the same as for the soprano recorder.
History
Recorders are known to have been made in different sizes since at least the 15th century, but a consistent terminology did not exist until the 20th-century revival of the instrument. In the early 16th century, books were published by Sebastian, Martin, and Sylvestro, all of which describe the smallest of three sizes of recorder as an instrument with the bottom note G. Appropriate to the highest instrument of the set, it is given a name used for the highest vocal part in music from that time: discant and sopran or soprano. At this time, recorders were made in a single piece. This type of instrument continued to be produced through the 17th century and into the early 18th, though around 1650 it began to be made in three separate parts. It was sometimes called the flauto italiano, particularly after about 1670 when a new type of recorder appeared in France, called flûte douce, what today would be called an alto in F. In contrast to the bright-toned flauto italiano, which was easy to play in the high register, the flüte douce was full and resonant in the low register, but was weak on the upper notes. This new version of recorder was first made in Paris and, shortly later and under French influence, in London. The redesign is traditionally attributed to the Hotteterres, particularly to Jean Hotteterre, though the evidence is rather tenuous. In 1696, Johann Christoph Denner and Johann Schell applied for permission to make the French type of instrument in Nuremberg, and it quickly became the dominant type of instrument across Europe. In most languages, this was the instrument meant by the word for flute alone: German Flöte, Dutch fluyt, Italian flauto, Spanish flauta. In England, it was usually simply "flute", but when necessary to differentiate from the transverse flute or other sizes of recorder, it was called "common flute" or "consort flute".
