Bullet voting is a voting tactic, usually in multiple-winner elections, where a voter is entitled to vote for more than one candidate, but instead votes for only one candidate. A voter might do this either because it is easier than evaluating all the candidates, or as a form of tactical voting. This tactic can be used to maximize the chance that the voter's favourite candidate will be elected, while increasing the risk that other favoured candidates will lose. A group of voters using this tactic consistently has a better chance for one favourite candidate to be elected. Election systems that satisfy the later-no-harm criterion discourage any value in bullet voting. These systems either do not ask for lower preferences or promising to ignore lower preferences unless all higher preferences are eliminated. Some elections have tried to disallow bullet voting, and require the casting of multiple votes, because it can empower minority voters. Minority groups can defeat this requirement if they are allowed to run as many candidates as seats being elected.
only allows a single vote, so bullet voting is effectively mandatory. Voting for more than one candidate is called an overvote and will invalidate the ballot. In contrast, approval voting allows voters to support as many candidates as they like, and bullet voting can be a strategy of a minority, just as in multiple winner elections. Such voting would be for their sincere favourite, so would not result in the same pathologies seen in Plurality voting where voters are encouraged to bullet vote for a candidate who is not their favourite. Bucklin voting and Borda voting used ranked ballots and both allow the possibility that a second choice could help defeat a first choice, so bullet voting might be used to prevent this. Instant-runoff voting and contingent vote allow full preferences to be expressed and lower preferences have no effect unless the higher ones have all been eliminated. Therefore bullet voting has no tactical advantage in these cases: on the contrary, it can lead to loss of influence, if no ranking is expressed among the final two candidates.
Multiple winner elections
Multiple votes are often allowed in elections with more than one winner. Bullet voting can help a first choice be elected, depending on the system:
Plurality-at-large voting allows up to N votes for elections with N winner elections. In this system, a voter who prefers a single candidate and is concerned his candidate will lose has a strong incentive to bullet vote to avoid a second choice helping to eliminate a first choice. Even so, a united majority of voters in plurality-at-large can control all the winners despite any strategic bullet voting by a united minority.
Approval voting used in a multi-winner election works the same way as Plurality-at-large, but allows more votes than winners. This results in a body that is less representative than a body elected under a proportional voting method, but would still have the same ideological center as the population. 100% bullet voting under Approval Voting in a multi-winner election is unlikely, as voters are incentivized to vote for acceptable moderates in addition to their favourite candidates to avoid being locked out of the election entirely.
* Range voting is a generalization of Approval voting where gradations of support can be given for each candidate. Here bullet voting would refer to giving 100% support for one candidate and 0% for all other candidates, just like Approval bullet voting.
* Borda voting assign multiple votes based on ranked ballots, like 3 votes for first, 2 votes for second, and 1 vote for third choice. This encourages minority voters to bullet vote. If voters are requires to rank all the candidates, it further encourages voters to bury strongest rivals at the lowest rankings.
Limited voting goes the opposite way as Approval, allowing fewer votes than winners. This reduces the ability of a united majority of voters to pick all the winners, and gives more influence to minority voters who would bullet vote anyway.
* A single nontransferable vote limits everyone to one vote, effectively making bullet voting mandatory, minimizing the power of a majority of voters to pick all the winners, and can work well if there are only a few more candidates as winners.
Cumulative voting allow up to N votes for N winner elections which can be distributed between multiple candidates or all given to one candidate. Effectively, this is one vote which can be fractionally divided among more than one candidate. This removes any penalty to bullet voters, who support a single candidate, and it enables the possibility of a united minority to elect at least one winner despite a united majority voting for all other candidates.
Instant runoff voting and Single transferable votetake away the incentive for bullet voting entirely since lower rankings are only used if all higher choices are elected or eliminated. STV goes one step further than IRV, computing a threshold for electability, like 20% for 4 candidates, and when a candidate is elected, supporters get a surplus fraction of their vote transferred to their next choice. This increases the value of giving full preferences.
Burr Dilemma
The Burr Dilemma exists in an election of multiple votes where a set of voters prefer two candidates over all other, while at best only one is likely to win. Both candidates have an incentive to publicly encourage voters to support the other candidate, while privately encouraging some supporters to only vote for themselves. This strategy when taken too far may cause too many defections from both candidates support so both of them lose, while avoiding defections prevents an effective choice between the two candidates. It is named after Aaron Burr in the U.S. Presidential election of 1800, by Professor Jack H. Nagel, where both Thomas Jefferson and Aaron Burr ran as Democratic-Republican.
