GAF Nomad


The GAF Nomad is a utility aircraft produced by the Government Aircraft Factories of Australia in Melbourne.
Supported by the Australian Government, design work began in the mid-1960s, and it made its maiden flight on 23 July 1971.
Despite some export sales and commercial operations, sales were not as sufficient and production stopped in 1985.
The twin-turboprop, high-wing aircraft has a retractable gear and came in two variants: the initial N22, followed by the stretched N24.
The Royal Flying Doctor Service of Australia, the Australian Army and the Australian Customs Service were major users.
The Australian military withdrew almost all of its remaining Nomads amid reports of safety concerns during the 1990s.
By the 21st century, only a handful of aircraft remained in regular use in Australia.
GippsAero acquired its type certificate in 2008 and plans to produce it again as the GA18.

Development

Origins

During 1965, development of what would become the Nomad commenced at GAF, although a considerable number of projects and design studies, including a compact twin-engined utility aircraft proposed by the Commonwealth Aircraft Corporation in the 1950s, had been conducted beforehand. In 1966, GAF contacted the Australian Army, seeking feedback on their proposal, which was of a single-engined turboprop-powered aircraft that could replace existing assets such as the American Cessna 180 and the Swiss Pilatus PC-6 Porter. The Army informed the company that, based on its combat experiences in Vietnam, the service believed a twin-engine configuration would be more useful to them. In the civil sector, an envisioned crop-dusting variant, viewed by GAF as a counterpart to the successful de Havilland Canada DHC-2 Beaver, was pitched to potential agricultural operators; they largely favoured using two engines, and noted that it ought to possess greater endurance and "hot-and-high" performance.
Based on feedback, GAF completely redesigned their proposal. This redesign was initially referred to as Project N; its basic configuration was of a twin-engined, multi-purpose transport aircraft. An original intention was that the entire rear fuselage would be hinged so that it could be swung open, providing generous rear-loading access to accommodate its target payload of a compact road vehicle; this choice necessitated the adoption of a raised cruciform tail. The new design was viewed as being a direct rival of existing products on the market from manufactures such as Britten-Norman, Shorts and de Havilland Canada. It was intended to be suitable for use by both local and overseas customers in both civil and military markets. According to aerospace periodical Flight International, it was apparent even at an early stage of the project that the programme could not be realistically accomplished without financial assistance from the Australian government, partly because the nation lacked a large domestic market.
During January 1970, the Australian government decided to provide $A3.2 million to GAF for the production of a pair of flight-capable prototypes along with a single static airframe for testing. The government was keen both to foster the growth of the nation's indigenous aviation industry and specifically to GAF to establish itself with a new aircraft in order to maintain aircraft production at the company, which was then set to end after the scheduled termination of license-produced Mirage III fighters. Furthermore, the twin-engined aircraft was viewed as a somewhat of a natural successor to the earlier DHA-3 Drover, a trimotor passenger airliner which had been built by de Havilland Australia.

Into flight

On 23 July 1971, the first prototype flew for the first time. By this point, the aircraft had been designated as the N2, and was being aimed at both the military and civilian markets. The designation N22 was to be used initially for military-orientated Nomads; this model, which was subsequently re-designated as N22B during production, was designed to perform military support operations, including aerial surveillance, medical evacuation, and other ancillary mission types. Furthermore, the N24A designation was assigned to a lengthened version of the Nomad; this was marketed as the principal commercial version.
On 5 December 1971, the second prototype performed its first flight. Reportedly, flight testing went relatively smoothly. A minor issue affecting the retraction of the undercarriage was quickly rectified, while directional stability was augmented by a 30 per cent increase in the area of both the fin and rudder. However, the programme was affected by a political dispute between the Army and the Royal Australian Air Force over whether the Army should continue to operate fixed-wing aircraft; this argument motivated the Australian Government to delay authorising production, causing several key figures of GAF's design team to resign in protest. During May 1972, production of the Nomad was finally authorised at a cost of $A13 million ; by this point, the Army had emerged from the row with success, being allocated 11 aircraft out of the first batch of 20 Nomads. At the same time, the conversion of one of the prototypes to represent a new stretched variant was also authorised.
In service, the Nomad was soon considered to be a problematic aircraft; early evaluations of the type performed by the military were frequently critical of it. Reportedly, safety concerns raised included fatigue issues with the tailplane, incorrect strength calculations having been used, and multiple questions surrounding the aircraft's overall aerodynamic stability and airworthiness. During August 1976, a high-profile failure occurred when a stretched-fuselage variant crashed, resulting in the deaths of both GAF's chief test pilot Stuart Pearce, and David Hooper, the chief structures designer. As of May 2007, the Nomad has been reportedly involved in a total of 32 total hull-loss accidents, which have cumulatively resulted in 76 fatalities.
During late 1980, by which point roughly 130 Nomads have been sold in both civil and military versions, the Australian Government gave its approval for GAF to proceed with the production of a further batch of 55 Nomads; this brought the authorised total production to 200 units, which was the forecast break-even point of the programme.

Termination and prospective revival

During 1985, production of the Nomad was terminated; in total, only 172 aircraft were manufactured, largely due to the limited number of foreign sales that had been secured by GAF. In 1986, GAF was incorporated into Aerospace Technologies of Australia, which has since been rebranded as Boeing Australia.
In June 2008, Gippsland Aeronautics announced it had won bidding to take over the Nomad's type certificate; the company also stated that it would probably be restarting production of new aircraft at some point. Prior to this acquisition, some of the GippsAero design and testing engineers, including the company's co-founder George Morgan, had worked for GAF during the Nomad's development. Reportedly, the N24-based GA18 was to be re-engineered with new powerplants and propellers, a glass cockpit, and would incorporate various weight-saving measures. It was planned to bring it into service after the development and certification of the new ten-seat GA10, which was due to be completed in March 2013.
, only one Nomad was still flying in Australia, although another four were operating in neighbouring New Zealand.

Design

The GAF Nomad is a twin-engine utility/commuter aircraft capable of Short Takeoff/Landing operations. It was produced in two primary variants, the N22B and N24A, the latter being 5 ft 10 in longer than the N22B; the N24A also differed by its larger nose compartment and separated access provided for the main baggage compartment, which was located aft of the cabin. Key features of the Nomad's general configuration included its rugged and straightforward design, STOL performance, its compact and economic engines and its relatively unobstructed and flat cabin floor. It had been designed to meet or exceed established military requirements of the era, as well as in compliance with regulations set out in the Federal Aviation Administration's FAR Part 23.
The Nomad was powered by a pair of Allison 250B17B/C turboprop engines, capable of generating up to 400 hp. Journalist Hugh Field observed the selection of this powerplant to be atypical, while its basic model had a strong reputation from its widespread use on helicopters, the Nomad was the first application of this engine model. GAF's design team, although reportedly having been initially hesitant about applying a new engine to a new airframe, praise the engine's behaviour upon the prototypes. In-flight, core engine operations could be controlled via a single lever, although additional controls are used for atypical actions such as Feathering. For ease of maintenance, the nacelles were built for easy access, while the engines consist of sub-assemblies that can be individually overhauled or replaced without extracting the entire engine.
The cabin of the Nomad has a continuous rectangular cross-section and a large freight door, both features favourable towards utility/freight operators. It has a full-width flat floor, complete with tie-down rails, which has been stressed to bear at least 150 lb/sq ft. While most commonly used as a baggage hold, the nose compartment could also be configured into a bay for housing various equipment packages, including radar systems, cameras, or laser scanning/ranging equipment. Externally, the flat underside of the fuselage could be furnished with a pair of hard points, suitable for the installation of mini-guns and other munitions; an additional four hard points can be fitted under the wings. To achieve an unobstructed fuselage, the two
spars of the strut-braced wing are not continuous, terminating at attachment points on the side of the fuselage.
According to Flight International, the adoption of a retractable undercarriage was a relatively unusual feature for an aircraft of this type; GAF designers selected this arrangement as to avoid excessive aerodynamic drag while enabling the use of large, widely spaced low-pressure tyres, these being key to allowing for rough field operations. Another uncommon feature for an aircraft of its class was the adoption of an all-moving tailplane. GAF suggested that a swing-tail variant could be easily produced due to an intentionally-designed manufacturing joint in the rear-fuselage that could act as a break point. The Nomad was made available in an amphibian variant; it was reportedly one of only a few aircraft in production to feature this facility during the 1980s. The Nomad also possesses a greater maximum cruise speed than most other strut-braced competitors, save for the de Havilland Canada DHC-6 Twin Otter.
The Nomad's cockpit, while typically fitted with dual flight controls, is designed to be operated by a single pilot. All of the primary controls are either duplicated or of a fail-safe design; both the flaps and undercarriage are electrically-actuated; to aid low-speed manoeuvring, an auto-flap button immediately selects 20° flap. For militarised models, the cockpit can be outfitted with Stanley Aviation zero-zero ejection seats, boron-carbide armour protection around the seats, forward bulkhead and side-panels, as well as bullet-resistant glass installed in the panels of windscreen. The cockpit reportedly possesses above-average external visibility in most directions.

Operational history

Civil use

According to aviation publication Flight International, the principal civil markets for the Nomad were the Pacific and North American regions. The stretched 16-seat N24A version was the main commercial variant and the most successful model of the Nomad in the United States. In the US market, the type was marketed and sold by the Hughes Aircraft Company, who acted as a distributor; by early 1981, Hughes had taken delivery of 20 Nomads, around half of those in commercial use at that point.

Military use

Australia

The Australian Army leased the second prototype N22 in 1973. It acquired 11 N22B between 1975 and 1977 for the 173rd Aviation Squadron. It subsequently acquired a 12th N22B from the Royal Australian Air Force in 1987. In 1993 the Army acquired eight more N22B and four N24A to replace its Pilatus PC-6 Porters. These 12 aircraft had been stored unsold when production ceased. All were withdrawn in 1995 following a report issued in May of that year which recommended the type's withdrawal from military duties amid concerns over airworthiness. Most were sold on to the Indonesian Navy, but two unflyable airframes are retained as training aids.
The Royal Australian Air Force acquired an N22B in 1977. Although owned by the RAAF, it was operated as part of the Army's 173rd Aviation Squadron and was eventually transferred to the Army in 1987. The RAAF subsequently acquired a former Coastwatch Nomad Searchmaster and three N24As in 1989, one which had been a GAF/ASTA test frame and two from a cancelled order for United States Customs Service. According to journalist Ian McPhedran, the Nomad became unpopular with military pilots due to safety concerns that weren't addressed by GAF and would sometimes refuse to fly the type. The RAAF decided to withdrawn most of its Nomads in 1993; several of the retired aircraft were sold onto Indonesia. This sale was not without controversy as it allegedly cost more to sell the aircraft than it would have to scrapped them.

Indonesia

The Indonesian Navy Aviation Service was an early customer for the type and would eventually operate a relatively large fleet. Between 1975 and 1977, it received acquired its first batch of 12 Nomad Searchmaster B and six Searchmaster L aircraft. Subsequently, Indonesia acquired a pair of N24As from the RAAF during 1993, quickly followed by 14 N22B and four N24A from the Australian Army in 1995; these were largely operated for aerial surveillance purposes. The 1990s purchases came at a cost of $2 million to Indonesia, but were supported by around $1 million per year of funding from Australia for the following decade. During 2011, it was announced that just over half of the Indonesian fleet was to be placed into storage and that only a handful of aircraft were to continue regular flight operations after this point.

Variants

;N.2 Nomad
;N.22
;N.22B
;N.22C
;N.22F Floatmaster
;N.24
;N.24A
;N.24B
;GA18
;Nomad Missionmaster
;Nomad Searchmaster
;Nomad N.22 Searchmaster B
;Nomad N.22 Searchmaster L
;Nomad N.22 Searchmaster LI
;Nomad N.22 Searchmaster LII

Operators

Civil operators

This list includes former Nomad operators.
;Thailand
;United States