Grashof number


The Grashof number is a dimensionless number in fluid dynamics and heat transfer which approximates the ratio of the buoyancy to viscous force acting on a fluid. It frequently arises in the study of situations involving natural convection and is analogous to the Reynolds number. It's believed to be named after Franz Grashof. Though this grouping of terms had already been in use, it wasn't named until around 1921, 28 years after Franz Grashof's death. It's not very clear why the grouping was named after him.

Definition

Heat transfer

Free convection is caused by a change in density of a fluid due to a temperature change or gradient. Usually the density decreases due to an increase in temperature and causes the fluid to rise. This motion is caused by the buoyancy force. The major force that resists the motion is the viscous force. The Grashof number is a way to quantify the opposing forces.
The Grashof number is:
where:
The L and D subscripts indicate the length scale basis for the Grashof number.
The transition to turbulent flow occurs in the range 108 < GrL < 109 for natural convection from vertical flat plates. At higher Grashof numbers, the boundary layer is turbulent; at lower Grashof numbers, the boundary layer is laminar that is in the range 103 < GrL < 106.

Mass transfer

There is an analogous form of the Grashof number used in cases of natural convection mass transfer problems. In the case of mass transfer, natural convection is caused by concentration gradients rather than temperature gradients.
where:
and:

Relationship to other dimensionless numbers

The Rayleigh number, shown below, is a dimensionless number that characterizes convection problems in heat transfer. A critical value exists for the Rayleigh number, above which fluid motion occurs.
The ratio of the Grashof number to the square of the Reynolds number may be used to determine if forced or free convection may be neglected for a system, or if there's a combination of the two. This characteristic ratio is called Richardson number. If the ratio is much less than one, then free convection may be ignored. If the ratio is much greater than one, forced convection may be ignored. Otherwise, the regime is combined forced and free convection.

Derivation

The first step to deriving the Grashof number is manipulating the volume expansion coefficient, ' as follows.
The in the equation above, which represents specific volume, is not the same as the in the subsequent sections of this derivation, which will represent a velocity. This partial relation of the volume expansion coefficient, ', with respect to fluid density, , given constant pressure, can be rewritten as
where:
There are two different ways to find the Grashof number from this point. One involves the energy equation while the other incorporates the buoyant force due to the difference in density between the boundary layer and bulk fluid.

Energy equation

This discussion involving the energy equation is with respect to rotationally symmetric flow. This analysis will take into consideration the effect of gravitational acceleration on flow and heat transfer. The mathematical equations to follow apply both to rotational symmetric flow as well as two-dimensional planar flow.
where:
In this equation the superscript n is to differentiate between rotationally symmetric flow from planar flow. The following characteristics of this equation hold true.
This equation expands to the following with the addition of physical fluid properties:
From here we can further simplify the momentum equation by setting the bulk fluid velocity to 0.
This relation shows that the pressure gradient is simply a product of the bulk fluid density and the gravitational acceleration. The next step is to plug in the pressure gradient into the momentum equation.
Further simplification of the momentum equation comes by substituting the volume expansion coefficient, density relationship, found above, and kinematic viscosity relationship,, into the momentum equation.
To find the Grashof number from this point, the preceding equation must be non-dimensionalized. This means that every variable in the equation should have no dimension and should instead be a ratio characteristic to the geometry and setup of the problem. This is done by dividing each variable by corresponding constant quantities. Lengths are divided by a characteristic length,. Velocities are divided by appropriate reference velocities,, which, considering the Reynolds number, gives. Temperatures are divided by the appropriate temperature difference,. These dimensionless parameters look like the following:
The asterisks represent dimensionless parameter. Combining these dimensionless equations with the momentum equations gives the following simplified equation.
where:
The dimensionless parameter enclosed in the brackets in the preceding equation is known as the Grashof number:

Buckingham π theorem

Another form of dimensional analysis that will result in the Grashof number is known as the Buckingham π theorem. This method takes into account the buoyancy force per unit volume, due to the density difference in the boundary layer and the bulk fluid.
This equation can be manipulated to give,
The list of variables that are used in the Buckingham π method is listed below, along with their symbols and dimensions.
VariableSymbolDimensions
Significant length
Fluid viscosity
Fluid heat capacity
Fluid thermal conductivity
Volume expansion coefficient
Gravitational acceleration
Temperature difference
Heat transfer coefficient

With reference to the Buckingham π theorem there are 9 – 5 = 4 dimensionless groups. Choose L, k, g and as the reference variables. Thus the groups are as follows:
Solving these groups gives:
From the two groups and the product forms the Grashof number:
Taking and the preceding equation can be rendered as the same result from deriving the Grashof number from the energy equation.
In forced convection the Reynolds number governs the fluid flow. But, in natural convection the Grashof number is the dimensionless parameter that governs the fluid flow. Using the energy equation and the buoyant force combined with dimensional analysis provides two different ways to derive the Grashof number.

Effects of Grashof number on the flow of different fluids

In a recent research carried out on the effects of Grashof number on the flow of different fluids driven by convection over various surfaces. Using slope of the linear regression line through data points, it is concluded that increase in the value of Grashof number or any buoyancy related parameter implies an increase in the wall temperature and this makes the bond between the fluid to become weaker, strength of the internal friction to decrease, the gravity to becomes stronger enough. The effects of buoyancy parameter are highly significant in the laminar flow within the boundary layer formed on a vertically moving cylinder. This is only achievable when the prescribed surface temperature and prescribed wall heat flux are considered. It can be concluded that buoyancy parameter has a negligible positive effect on the local Nusselt number. This is only true when the magnitude of Prandtl number is small or prescribed wall heat flux is considered. Sherwood number, Bejan Number, Entropy generation, Stanton Number and pressure gradient are increasing properties of buoyancy related parameter while concentration profiles, frictional force, and motile microorganism are decreasing properties.