Harvard Mark III


The Harvard Mark III, also known as ADEC was an early computer that was partially electronic and partially electromechanical. It was built at Harvard University under the supervision of Howard Aiken for the US Navy.

Technical overview

The Mark III's word consisted of 16 bits. It used 5,000 vacuum tubes and 1,500 crystal diodes. It weighed. It used magnetic drum memory of 4,350 words. Its addition time was 4,400 microseconds and the multiplication time was 13,200 microseconds. Aiken boasted that the Mark III was the fastest electronic computer in the world.
The Mark III used nine magnetic drums. One drum could contain 4,000 instructions and has an access time of 4,400 microseconds; thus it was a stored-program computer. The arithmetic unit could access two other drums – one contained 150 words of constants and the other contained 200 words of variables. Both of these drums also had an access time of 4,400 microseconds. This separation of data and instructions is known as the Harvard architecture. There were six other drums that held a total of 4,000 words of data, but the arithmetic unit couldn't access these drums directly. Data had to be transferred between these drums and the drum the arithmetic unit could access via registers implemented by electromechanical relays. This was a bottleneck in the computer and made the access time to data on these drums long – 80,000 microseconds. This was partially compensated for by the fact that twenty words could be transferred on each access.
The Mark III was finished in September 1949 and delivered to the U.S. Naval Proving Ground at the US Navy base at Dahlgren, Virginia in March 1950. Operational in 1951.