Isotopes of bohrium


is an artificial element, and thus a standard atomic weight cannot be given. Like all artificial elements, it has no stable isotopes. The first isotope to be synthesized was 262Bh in 1981. There are 11 known isotopes ranging from 260Bh to 274Bh, and 1 isomer, 262mBh. The longest-lived isotope is 270Bh with a half-life of 1 minute, although the unconfirmed 278Bh may have an even longer half-life of about 690 seconds.

List of isotopes

Nucleosynthesis

s such as bohrium are produced by bombarding lighter elements in particle accelerators that induce fusion reactions. Whereas most of the isotopes of bohrium can be synthesized directly this way, some heavier ones have only been observed as decay products of elements with higher atomic numbers.
Depending on the energies involved, the former are separated into "hot" and "cold". In hot fusion reactions, very light, high-energy projectiles are accelerated toward very heavy targets, giving rise to compound nuclei at high excitation energy that may either fission or evaporate several neutrons. In cold fusion reactions, the produced fused nuclei have a relatively low excitation energy, which decreases the probability that these products will undergo fission. As the fused nuclei cool to the ground state, they require emission of only one or two neutrons, thus allowing for the generation of more neutron-rich products. The latter is a distinct concept from that of where nuclear fusion claimed to be achieved at room temperature conditions.
The table below contains various combinations of targets and projectiles which could be used to form compound nuclei with Z = 107.
TargetProjectileCNAttempt result
208Pb55Mn263Bh
209Bi54Cr263Bh
209Bi52Cr261Bh
238U31P269Bh
243Am26Mg269Bh
248Cm23Na271Bh
249Bk22Ne271Bh

Cold fusion

Before the first successful synthesis of hassium in 1981 by the GSI team, the synthesis of bohrium was first attempted in 1976 by scientists at the Joint Institute for Nuclear Research at Dubna using this cold fusion reaction. They detected two spontaneous fission activities, one with a half-life of 1–2 ms and one with a half-life of 5 s. Based on the results of other cold fusion reactions, they concluded that they were due to 261Bh and 257Db respectively. However, later evidence gave a much lower SF branching for 261Bh reducing confidence in this assignment. The assignment of the dubnium activity was later changed to 258Db, presuming that the decay of bohrium was missed. The 2 ms SF activity was assigned to 258Rf resulting from the 33% EC branch. The GSI team studied the reaction in 1981 in their discovery experiments. Five atoms of 262Bh were detected using the method of correlation of genetic parent-daughter decays. In 1987, an internal report from Dubna indicated that the team had been able to detect the spontaneous fission of 261Bh directly. The GSI team further studied the reaction in 1989 and discovered the new isotope 261Bh during the measurement of the 1n and 2n excitation functions but were unable to detect an SF branching for 261Bh. They continued their study in 2003 using newly developed bismuth fluoride targets, used to provide further data on the decay data for 262Bh and the daughter 258Db. The 1n excitation function was remeasured in 2005 by the team at the Lawrence Berkeley National Laboratory after some doubt about the accuracy of previous data. They observed 18 atoms of 262Bh and 3 atoms of 261Bh and confirmed the two isomers of 262Bh.
In 2007, the team at LBNL studied the analogous reaction with chromium-52 projectiles for the first time to search for the lightest bohrium isotope 260Bh:
The team successfully detected 8 atoms of 260Bh decaying by alpha decay to 256Db, emitting alpha particles with energy 10.16 MeV. The alpha decay energy indicates the continued stabilizing effect of the N=152 closed shell.
The team at Dubna also studied the reaction between lead-208 targets and manganese-55 projectiles in 1976 as part of their newly established cold fusion approach to new elements:
They observed the same spontaneous fission activities as those observed in the reaction between bismuth-209 and chromium-54 and again assigned them to 261Bh and 257Db. Later evidence indicated that these should be reassigned to 258Db and 258Rf. In 1983, they repeated the experiment using a new technique: measurement of alpha decay from a decay product that had been separated out chemically. The team were able to detect the alpha decay from a decay product of 262Bh, providing some evidence for the formation of bohrium nuclei. This reaction was later studied in detail using modern techniques by the team at LBNL. In 2005 they measured 33 decays of 262Bh and 2 atoms of 261Bh, providing an excitation function for the reaction emitting one neutron and some spectroscopic data of both 262Bh isomers. The excitation function for the reaction emitting two neutrons was further studied in a 2006 repeat of the reaction. The team found that the reaction emitting one neutron had a higher cross section than the corresponding reaction with a 209Bi target, contrary to expectations. Further research is required to understand the reasons.

Hot fusion

The reaction between uranium-238 targets and phosphorus-31 projectiles was first studied in 2006 at the LBNL as part of their systematic study of fusion reactions using uranium-238 targets:
Results have not been published but preliminary results appear to indicate the observation of spontaneous fission, possibly from 264Bh.
Recently, the team at the Institute of Modern Physics, Lanzhou, have studied the nuclear reaction between americium-243 targets and accelerated nuclei of magnesium-26 in order to synthesise the new isotope 265Bh and gather more data on 266Bh:
In two series of experiments, the team measured partial excitation functions for the reactions emitting three, four, and five neutrons.
The reaction between targets of curium-248 and accelerated nuclei of sodium-23 was studied for the first time in 2008 by the team at RIKEN, Japan, in order to study the decay properties of 266Bh, which is a decay product in their claimed decay chains of nihonium:
The decay of 266Bh by the emission of alpha particles with energies of 9.05–9.23 MeV was further confirmed in 2010.
The first attempts to synthesize bohrium by hot fusion pathways were performed in 1979 by the team at Dubna, using the reaction between accelerated nuclei of neon-22 and targets of berkelium-249:
The reaction was repeated in 1983. In both cases, they were unable to detect any spontaneous fission from nuclei of bohrium. More recently, hot fusions pathways to bohrium have been re-investigated in order to allow for the synthesis of more long-lived, neutron rich isotopes to allow a first chemical study of bohrium. In 1999, the team at LBNL claimed the discovery of long-lived 267Bh and 266Bh. Later, both of these were confirmed. The team at the Paul Scherrer Institute in Bern, Switzerland later synthesized 6 atoms of 267Bh in the first definitive study of the chemistry of bohrium.

As decay products


Evaporation residueObserved bohrium isotope
294Lv, 290Fl, 290Nh, 286Rg, 282Mt ?278Bh ?
294Ts, 290Mc, 286Nh, 282Rg, 278Mt274Bh
288Mc, 284Nh, 280Rg, 276Mt272Bh
287Mc, 283Nh, 279Rg, 275Mt271Bh
282Nh, 278Rg, 274Mt270Bh
278Nh, 274Rg, 270Mt266Bh
272Rg, 268Mt264Bh
266Mt262Bh


Bohrium has been detected in the decay chains of elements with a higher atomic number, such as meitnerium. Meitnerium currently has seven known isotopes; all of them undergo alpha decays to become bohrium nuclei, with mass numbers between 262 and 274. Parent meitnerium nuclei can be themselves decay products of roentgenium, nihonium, flerovium, moscovium, livermorium, or tennessine. To date, no other elements have been known to decay to bohrium. For example, in January 2010, the Dubna team identified bohrium-274 as a product in the decay of tennessine via an alpha decay sequence:

Nuclear isomerism

;262Bh
The only confirmed example of isomerism in bohrium is in the isotope 262Bh. Direct synthesis of 262Bh results in two states, a ground state and an isomeric state. The ground state is confirmed to decay by alpha decay, emitting alpha particles with energies of 10.08, 9.82, and 9.76 MeV, and has a revised half-life of 84 ms. The excited state also decays by alpha decay, emitting alpha particles with energies of 10.37 and 10.24 MeV, and has a revised half-life of 9.6 ms.

Chemical yields of isotopes

Cold fusion

The table below provides cross-sections and excitation energies for cold fusion reactions producing bohrium isotopes directly. Data in bold represents maxima derived from excitation function measurements. + represents an observed exit channel.
ProjectileTargetCN1n2n3n
55Mn208Pb263Bh590 pb, 14.1 MeV~35 pb
54Cr209Bi263Bh510 pb, 15.8 MeV~50 pb
52Cr209Bi261Bh59 pb, 15.0 MeV

Hot fusion

The table below provides cross-sections and excitation energies for hot fusion reactions producing bohrium isotopes directly. Data in bold represents maxima derived from excitation function measurements. + represents an observed exit channel.
ProjectileTargetCN3n4n5n
26Mg243Am271Bh+++
22Ne249Bk271Bh~96 pb+