Jeep DJ


The Jeep DJ was a two-wheel-drive variant of the four-wheel drive CJ series. Production started in 1955 by Willys, which was renamed Kaiser Jeep in 1963. In 1970, American Motors purchased Kaiser’s money-losing Jeep operations and established AM General, a wholly owned subsidiary that built the DJ through 1984.

DJ-3A

The DJ-3A was introduced in 1955. It used the body style of the older CJ-3A, along with the L-134 engine. Unlike the CJ-3A, it came with either a column shift or floor shift three-speed Borg-Warner T-96 manual transmission. It was offered with many different body options including a soft top, hard top, or even a full van body. One model was a postal delivery vehicle with the driver's position on the right side for mail box delivery
In early 1959, Willys introduced the Jeep Gala to the export markets and uses desiring the nimble size and open bodywork, but no need for four wheel-drive. This model gained popularity as a "fun car" at resorts in Hawaii, Mexico, and islands in the Caribbean area. It was finished in pink, green, or blue and trimmed with matching white striped fabric, as well as with fringe on its top.
In fall 1959, a similar model called the Jeep Surrey was introduced in the US market. The primary target market were resort hotels and vacation centers. It also served as a low-cost rental vehicle for their guests. The Surrey came with a standard striped fabric top, as well as a matching fabric cover for what was advertised as a "Continental tire mount."
Gallery

DJ-5 and DJ-6

The DJ-3A was replaced by the right hand drive DJ-5 Dispatcher 100 in 1965. It was based on the CJ-5 and used the Hurricane and Dauntless engines. A longer wheelbase DJ-6 model was built from 1965 to 1973 alongside the CJ-6.

DJ-5A through DJ-5M

The DJ-5A was introduced in 1967, beginning the lettering system indicating changes within the series.
The DJ-5A used a standard CJ front end, with a four-cylinder Chevrolet Nova engine and two-speed Powerglide automatic transmission, with a T-handle shifter located on the floor next to the driver's seat. The main body was a single unit, resembling the earlier Jeep when equipped with the metal Extreme Cold Weather Enclosure hard top.
The models used by the United States Post Office had right-hand drive, and were built in a lighter, less durable design than the standard Jeep. These changes included the use of C-channel frame rails and, while the hood was the same dimensions as the CJ, it did not have the reinforced design of the original. Also, the standard configuration had only a driver's seat and a letter tray installed. This decreased curb weight, combined with different leaf springs than other models, allowed carrying more cargo weight behind the driver.
The metal side doors were also designed to slide open and closed, and could be locked open while driving. They were supported by ball bearings, which ran in a channel just under the rain gutter, and a plastic retainer ran in a small channel along the body. A worn, damaged or lost retainer would allow the door to swing outward, fail to engage the rubber stop on the rear bumper, and slide all of the way off of the channel. A single, hinged rear door gave access from floor to the bottom of the hard top, and was the width of the open area between the wheel wells.
There were no cutouts in the body for the rear wheels, which made tire changes more difficult, as even when the frame was jacked well off the ground, the axle did not fall enough for the tire to clear the body. The DJ-5A used standard 15-inch passenger car tires, with no provision for carrying a spare. While the front bumper was of the standard CJ design, the rear bumper was a unique design, a single stamped part which ran the full width of the vehicle. At each end was a rubber stopper for the sliding doors. The 10-gallon fuel tank was under the rear body, just ahead of the bumper.
In 1971, a unique five-slot grille without turn signals that was used only on postal Jeeps was introduced. The 1971 model actually has the grille extend past the front of the hood edge. This allowed more room for the AMC Straight-6 engine and radiator. Like the DJ-5A, while resembling the CJ series, these were built as a completely enclosed, rear-wheel drive vehicle, with sliding side doors, and a swinging rear door. Most models only had the driver's seat and a mail tray where the second seat would normally be located. One improvement over earlier Jeeps was mounting the rear springs outside of the frame rails, thus providing greater stability for the vehicle with its top-heavy enclosed cargo area, especially at highway speeds. Most models were also equipped with a limited slip differential and a heavy-duty steering gearbox. Other improvements include a vent in the roof and cut-outs around the rear tires.
AM General used a variety of powerplants during production. DJ production was ended in 1984 with the DJ-5M, which used the AMC straight-4 engine.
Gallery

DJ-5E Electruck

American Motors experimented with electric vehicles and starting in 1974 mass-produced the DJ-5E, a rear-wheel drive electric delivery van, also known as the Electruck.
Similar in appearance and in most of its dimensions, the DJ-5E was powered by a set of two 27-volt lead-acid batteries with a 54-volt compound wound DC motor with electronic regulation made by Gould Electronics. The U.S. Postal Service purchased 352 vehicles for the use in cities with serious air pollution. The Electruck was capable of cruising at with a range of with 20% of its battery power still remaining in reserve.

Model numbers