Jumping position


The jumping position is a position used by equestrians when jumping over an obstacle. It usually involves what is known as the "forward seat" or "2 point" because the rider's legs provide two points over which the rider's weight is balanced on the horse. It was first developed by Captain Federico Caprilli. This involves the rider centered over his or her feet, with the stirrup leathers perpendicular to the ground. Continuing a line upwards from the stirrup leathers, the head and shoulders fall in front of the line, as do the knees, the hips fall behind it.
A correct jumping seat serves two purposes:
The jumping seat is not meant to be held by the rider, but rather it is a fluid seat that changes as the horse's balance changes. It keeps the rider in a position over the horse's center of gravity.
It is important to note that the horse, not the rider, is responsible for opening and closing the rider's angles. As the horse takes off, it raises its upper body off the ground and comes closer to the rider. This makes the rider's hip angle close. Over the fence, the rider keeps the angles closed. As the horse lands, it moves away from the rider's body, which allows the hip angle to open and the rider to become more perpendicular to the ground. Also, if the horse takes a jump wrong in some manner, due to rider error or other, the rider may be thrown around a little bit and may sometimes get 'left behind', where the rider's center of balance is behind that of the horse's. This can also throw the horse off balance and lead to other problems such as knocking down a rail.

Position of the leg

The lower leg is the anchor of the rider's position, and contributes a great deal to his security. Poor lower leg position makes a rider more likely to lose balance over fences, and therefore increases the chance that he may fall. It also tends to decrease the ability of the rider to communicate clearly with his or her horse.
The leg should hang down the horse's side, making even contact along its whole length, and should not change position when the upper body moves. The rider's weight is dropped along the back of the leg and into the heel through a flexible ankle, so that the heel is lower than the toes. The toes are generally turned out slightly, to a degree greater than in the flatwork-only English riding disciplines such as dressage or saddle seat. This places the back of the calf against the horse, instead of the whole inner calf as in dressage, which decreases the refinement in communication between horse and rider, but anchors the rider and increases security. Toes should turn no more than 45 degrees out.
The stirrups are shortened from the length used for flatwork, adjusted according to the height of the fence. Grand Prix jumpers and eventers on cross-country generally need to shorten the stirrups the most, to allow them to gallop and jump in motion with their horse. The short stirrup provides more leverage and flexibility, and therefore security, better balance and a more secure position should the horse stumble, get a poor distance, or peck on landing. More importantly, a shorter stirrup allows the rider to get off the horse's back between and over the fence, freeing up the back and allowing the horse to bascule. The stirrup leather should remain perpendicular to the ground. The stirrup iron is usually placed on the ball of the foot, allowing the rider to have a flexible, shock-absorbing ankle. The rider should keep even pressure across the foot, rather than pushing on the inside or outside of the stirrup iron, as this makes the lower leg stiff.
The result of a shorter stirrup is that the ankle and knee angle decrease. Both the angles are used as shock-absorbers, opening and closing accordingly with the thrust of takeoff and landing. Stiffness in these angles makes it harder to stay with horse's balance, which may result in the riders "jumping ahead" or being "left behind."

Variations in leg position

Leg position may vary slightly between disciplines. Combining a relatively short stirrup with a need for security, Eventers and steeplechase jockies tend to have a slightly forward leg position, with the foot "home" in the iron. The more forward leg position increases security, making it more difficult for the rider to become dislodged. This is important in both sports because riders jump solid fences at high speed, where the horse is more likely to stumble or fall if it hits the fence. Especially in the case of steeplechase jockey, a fall could be extremely dangerous, as the other horses in the race could trample him or her.
The foot can be placed "home" for security purposes. This decreases the chance that the rider will lose a stirrup should a horse jump or land awkwardly. However, this is very dangerous in the manner that should the rider fall, the foot may become caught in the iron and a rider could be dragged by the horse, ending in serious injury or death.

Position of the seat, hips, and thighs

The rider keeps his or her weight toward the pelvis, and generally has enough weight in the stirrups to be suspended in the air over the saddle, rather than sitting on the horse's back. The rider should not bring the hips too far forward, over the pommel, as seen in the fault of jumping ahead. This changes the rider's balance, and creates a potentially dangerous position.
The hip joints are especially important, as they are the connection between the lower leg, and the upper body. The hips should be very flexible, opening and closing as needed. The hips should always move backward from the neutral position, not forward.
Between fences, the rider may ride in two-point position, where the thighs take up weight of rider, not the seatbones. Another position used in galloping, when additional control is needed, is the "half seat," which resembles two-point position, but the rider's seat bones lightly touch the saddle. At slower speeds, or if considerable control is needed, the rider may sit down on the horse, where the seat bones touch the saddle.

Position of the Upper body (shoulders, head, trunk)

In all disciplines, the rider should be looking up and in the direction of where he or she needs to go on landing. Looking down tends to cause riders to lean forward with the shoulders and round their back, thus placing them in a precarious position. The head should also not be tilted to one side, as this changes the rider's lateral balance and places more weight on one side.
In general, the back should be flat. Overarching causes stiffness, rounding not only looks bad, but affects the rider's balance. A slightly rounded back is acceptable cross-country when used in the safety seat.
The rider should have an open chest with shoulders back. This helps to prevent the rider from collapsing forward and helps to center the weight of the upper body over the lower leg, therefore helping to keep the rider secure.

Releases

In all cases, the rider should release the horse over a fence, or in other words, lengthen enough rein so the horse can stretch its neck forward and use it as a balancing mechanism. The key to a good release is relaxed arms with proper hand, wrist, and elbow position. First, the arms should be soft and elastic, allowing the horse to pull them forward as needed. Preferably, there should be a straight line from bit to elbow, as this improves contact and communication between horse and rider. The wrists of the rider should remain soft and straight, as bent wrists tend to stiffen the lower arm. The elbows should be next to the rider's side, not "chicken-winged" and pointing outward, which decreases flexibility and softness.
As in all riding, the hands should be softly closed, neither tightly holding the reins which causes tension and stiffness, or so soft that the reins easily slip through. The one exception to this rule is when the rider needs to slip the reins.

Types of releases

There are three classic releases. Different releases are used depending on circumstances. However, all riders should strive to readily be able to use each one as needed, and should practice them all.
Basic release: the rider grabs the mane of the horse. This allows the rider to avoid falling back and hitting the horse in the mouth or back, or try to use the mouth for balance. It is used by beginning riders who do not yet have the position and balance to do more advanced releases without risking hitting their horse in the mouth. It is also used by more advanced riders on green horses, who tend to overjump, or when a rider for some reason loses position due to an awkward jump. Riders should not think it is reserved for novices, and all good riders will grab mane to save their horse's mouth. However, it provides the least amount of control. It should therefore not be used if it is not required. It can also be used for galloping, where the riders weight should be in the heels, therefore giving the horse freedom.
Short crest release: the rider slides the hands up the crest as the horse takes off, not before. The hands should not slide far up the crest, only a couple inches, as needed. It provides support for the rider's upper body, while still providing a good amount of control because the rider did not release any more than needed. Best used on verticals, when the rider needs to turn mid-air, or when going down drop fences. An intermediate release.
Long crest release: Similar to the short crest release, in that the rider slides his hands up the crest, but the hands are pushed much further along the neck. Gives a great deal of freedom, but fairly little control. Best for very wide oxers, to allow the horse to really stretch across, or for green horses that may jump large or awkwardly, for gymnastics grids, and for use on horses that have been hit in the mouth over fences and are reluctant to jump or stretch down over a fence. The rider should be careful not to associate a large movement forward with the hands and elbows to mean a movement forward with the hips. The hip angle should still close backward. Many riders get into the habit of jumping ahead with this release. Critics say this release is overused and exaggerated by hunter riders; in the hunter ring it is often used by experienced and/or professional riders on well-trained horses over jumps of relatively modest size. Proponents say that this shows off a talented hunter by proving the horse needs little assistance from the rider to jump in good form.
Automatic release: The most advanced release, where the rider maintains a soft, elastic, steady rein contact with a straight line from elbow to bit as the horse jumps. This release results in a great deal of control and communication between horse and rider, allowing the rider to signal to the horse what to do on landing. It allows the rider to better turn while in the air, to correct horses that jump crookedly, and to provide the support that some horses prefer over fences. It is also good on horses that need lots of control after landing. However, the automatic release requires perfect balance from the rider to be executed correctly. An unsteady rider will catch the horse in the mouth, and an incorrect automatic release will spoil a horse's jump and confidence. However, if a rider is able to perform it correctly, it is often best to use this release whenever possible. Very useful in show jumping and eventing, where control is very important.
Slipping the reins: Not a release, rather, simply letting the reins slide through the hands a bit. It is a very valuable tool all riders should have. To be used when the rider gets behind the motion by accident, when riding drop fences or fences with a downhill landing, or when a horse gets in trouble over a fence. Allows the rider to release the horse and give him the freedom he needs, without forcing the rider to do one of the other releases. However, it results in extra long reins on landing, so the rider must be able to immediately gather up the reins and shorten them to the correct length.
With experience, riders learn by feel to instinctively choose the correct release.

Common Faults