Lotus 23
The Lotus 23 was designed by Colin Chapman as a small-displacement sports racing car. Nominally a two-seater, it was purpose-built for FIA Group 4 racing in 1962–1963. Unlike its predecessors Lotus 15 and 17, the engine was mounted amidship behind the driver in the similar configuration developed on Lotus 19.
The 23
To comply with FIA rules, it had a regulation trunk space to the right-rear of the driver, a windshield wiper, a horn, pairs of headlights and tail lights, rear center license plate light, a wire-operated emergency brake, and a mounting space for one spare tire under the front body. The 23 used a wider version of the Lotus 22 space frame, clothed in a fibreglass body.The front suspension was a typical double wishbone arms with outboard coil/damper unit using the Triumph upright made by Alford & Alder, Triumph Herald rack and pinion steering, and outboard Girling non-ventilated disc brake. The rear had the top link with lower reversed wishbone, top and bottom radius arms with the top arm at the height of the halfshaft, combined with the outboard disc brakes and coil/damper unit. Unlike the arrangement for Lotus 20 suspension, the halfshafts had Metalastic rubber 'doughnuts' on the inside, carrying no cornering forces. The side forces are carried by the lower wishbone, together with the top 'I' arm link, which connects the tail end of the upper side tube in the frame with the extended top end of cast alloy upright.
The tie-rod end, front top and bottom wishbone outside joints and the rear lower wishbone inside joint were Heim joints. The rest of the suspension joints were rubber joint, with joint-mounting pipes welded onto the ends of suspension arms. While most of the suspension arms were in common with Lotus 22, the angle of the rear radius arms on the plan view was different from the narrower-frame Lotus 22, so they were not interchangeable with the 22.
It was originally intended for engines of 750 cc to 1300 cc with a Renault 4-speed transaxle, but had a 5-speed Hewland Mk.III in production, which used the entire Volkswagen magnesium alloy transaxle case in upside-down configuration, housing bespoke straight-cut gears with dog-rings, and the Volkswagen differential gear set. Unlike the later Mk.IV, the Mk.III had the shifter rod at the end of the VW nose casing, so the shifting rod from the centre shifter knob location extended to the tail end of the chassis.
On the frame structure, the lower side pipes and the width-wise lower pipe behind the cockpit were rectangle tubes, with most of the other frame pipes being round steel tubes in various diameter. The upper left round pipe was used as the water feed pipe for the radiator up front, and the lower right side pipe and a half of the width-wise lower rear cockpit pipe was the return tube. Likewise, the upper right side pipe was the oil feed to the oil cooler, and the lower left tube was the return. This frame was mostly made by Arch Motors, carrying 'AM' serial number.
This configuration was shared with Lotus 22 and other Formula cars of the time, but the combination of a wider and thus larger radiator, wider steel frame acting as a cooling device, and the small displacement engines resulted in more than ample cooling capacity. Atypical of the contemporary racing cars, Lotus 23 models sometimes experienced an over-cooling problem in sprint races, and displayed a very stable water temperature in endurance racing.
The 23B
The 23B in 1963 had the original center gear shifter relocated to the right side of the driver, and the radiator and oil cooler were combined into a single unit, with the lower 1/5 or so acting as the oil cooler. The frame received additional structural tubes to take the torque of Lotus TwinCam-based 1.6 litre Cosworth Mk.XII and Mk.XIII, mated to "high torque spec" 5-speed Hewland Mk.V transaxle. Smaller displacement engines were mated to 5-speed Hewland Mk.IV. Both the Mk.IV and Mk.V transaxles had GKN differential gears and a forward-facing selector rod on the right side in a bespoke tail casing.The intake funnels on the Weber carburetors on 23B were housed in a "cold air box" which received fresh air from two oval holes cut out on the top side of the rear body behind the driver.
The 23C
The 23B proved to be very successful in being a "giant killer" often beating cars in larger classes, but the limited road adhesion due to the narrow tyre width became apparent as the shortcoming in running with the larger cars. The 23C was developed using much wider Formula Two tyres mounted on wider 6-stud wobbly-web wheels front and rear. The body received wing-extensions to cover the wider tyres, with the characteristic 23/23B rear wings cut-out to expose the entire tyre/wheel in the side view.Lotus 23 proved a competitive, durable, and popular race car. These cars are still a mainstay of vintage racing in Europe and the United States today.
Including the 23B and 23C, about 130 examples were made in period, but the popularity of the model led to many additional cars assembled from replacement and reproduction parts. The current estimate on the total number ranges between 200 and 400 excluding [|Xanthos] and [|Noble].
Debut at the Nürburgring
The debut of the 23 was at the Nordschleife in May 1962. The tiny Lotus 23 with the newly developed 1.5 litre Lotus TwinCam engine shot away from the field of Porsches, Aston Martins and Ferraris with Jim Clark at the wheel in the rain. Even though some cars had four times the power of the Lotus, after the first lap in the wet, Clark was 27 seconds ahead of Dan Gurney's Porsche. Extending his lead on each lap until the track dried, Clark was overcome by exhaust fumes from a damaged exhaust manifold on lap 12 and crashed out.Banned from Le Mans
With the sensational Nürburgring debut well publicised in the press, two 23s were entered at Le Mans in June 1962. One with a aluminium-block DOHC Coventry Climax FWMC with drivers Les Leston / Tony Shelly, and another with one litre Iron block pushrod Cosworth Mk.III with drivers Jim Clark / Trevor Taylor.The 23s failed to pass the scrutineering on several technical grounds, including an insufficient windscreen height, fuel tank capacity being too large, turning circle too large, ground clearance too small, and the spare tyre requirement not met. Fitted with a makeshift tall wind screen, all but the spare tyre issue was rectified almost immediately.
The original 23 and the later 23B had 4 stud front and 6 stud rear wobbly-web wheels, and carried the narrower and lighter front wheel with its tyre mounted as the spare.
The French scrutineers argued the requirement to carry a spare tyre is for the purpose of changing a flat, which is not satisfied by the 23 in the case of a flat occurring on one of the rear tyres. So the Lotus factory had a 4 stud rear hubs drafted and machined over-night, and had a person carry them and flown to Le Mans the next day. After being presented with the 23s with 4 stud rears installed, the scrutineers rejected again on the grounds that the 6 stud configuration must have been a reflection of strength requirement in the original design, so the 4 stud configuration was deemed unsafe. This is a rare of Les Leston Lotus 23 with tall windscreen and 4 stud rear hub.
The scrutineers and the ACO did not change this position even after Mike Costin, the Lotus engineer on site, offered to go over structural analysis calculations showing the difference falls within the safety margin built in the design to accommodate more powerful Cosworth Mk.IV and Cosworth Mk.VII engines.
One of the two Lotus 23s with 4 stud rears, with Cosworth Mk.III engine, was sold off sans engine on the spot to the 1 litre class winning driver of the event, with a lease on the engine and support contract attached, on a strict condition imposed by Chapman to keep the 4 stud configuration for longer than one racing season. The French driver/buyer, Bernard Consten, not only obliged but won Clermont-Ferrand 6 Hours and 1000 km of Montlhery that year with this 23 without breaking the studs, the hub, or the wheel.
Team Lotus remained on the scene for the entire 1962 event supporting and winning the 1.3 litre GT class and the Index of Performance prize by a Lotus Elite driven by David Hobbs and Frank Gardner. ACO officials then made the situation worse in admitting a mistake, offering a financial compensation for the 23 entries after the race. With pro-Lotus motoring journalist Gérard Crombac present as the interpreter in the meeting, Chapman suggested a figure which was too large for the officials to swallow. Upon being rejected, Chapman vowed "We will never race again at Le Mans!", a promise that Lotus kept until 1997, long after Chapman's death in 1982.
Chapman believed the fiasco was caused by the French contender for Index of Thermal Efficiency award, René Bonnet. Gérard Crombac knew of a competitor to Bonnet, Jean Rédélé's ambition to beat the then-dominant Automobiles René Bonnet in thermal efficiency at Le Mans, and gave the idea of helping Alpine instead of subsequent direct participation to Chapman. As a result, a 2-seater racing prototype was designed by a team of Lotus employees, Len Terry, Bob Dance and Keith Duckworth, based on Lotus 23.
This design was found to be non-compliant to the 1963 Le Mans regulations, so the frame structure was changed to a steel backbone design familiar to Rédélé's team at Alpine, and became the Alpine M63. M64 of 1964 had the original frame designed by Terry, and the French Alpine M63 and M64 could fit British 6-stud Wobbly Web wheels as a testament.
In 1964 Le Mans, Alpine won the Index of Thermal Efficiency with the M64 while setting a new distance record for the 1150cc Prototype class, with a M63B in the second place. Alpine went on to become the Le Mans overall winner in 1978.
Restoration and replication of the Lotus 23
Beginning in the early 1980s a small group of enthusiasts began to make it possible to restore original Lotus 23 by remanufacturing parts. These parts are now easily available. It was at about this time that a Register was established for the Lotus 23. That Register is now part of the Historic Lotus Register of the UK. Some race organizers and the Historic Motor Sports Association began in 2007 to take steps to restrict race participation by replica cars.There are several sources of replicas of Lotus 23 cars.