M32 Tank Recovery Vehicle


The M32 Armored Recovery Vehicle was an armored recovery vehicle used during World War II and the Korean War by the United States, and was based on the chassis of the M4 Sherman. During World War II, the British also used several hundred M32s, which were obtained through Lend-Lease in 1944. The first four prototypes were produced in January 1943, labeled T5, T5E1, T5E2, T5E3, and T5E4. After a series of tests at the Aberdeen Proving Grounds, the prototypes were approved as M32, M32E1, M32E2, M32E3, and M32E4. However, the M32E4 never entered production. There were also variants that had Horizontal Volute Spring Suspension, which were demarcated by an A1 after the model.
Lima Locomotive started production of the vehicles in June 1943, with five M32B2s and 46 M32B3s. Pressed Steel Car produced 163 M32s and 475 M32B1s in 1944. They also produced 298 M32B3s. Baldwin Locomotive produced 195 M32B1s, while 398 M32B1s were produced by Federal Machine before the end of 1944. Many M32s were converted into M34 Prime Movers, used to pull heavy artillery. The M32s were used after 1944 during Operation Overlord and subsequent battles in the European Theater of Operations. It was also used during the Korean War. It was phased out after the introduction of the M74 Tank Recovery Vehicle in 1954, when heavier tanks were produced, such as the M46 Patton. The M32 had a winch, boom, and an A-frame jib. It was armed with two machine guns and a mortar mainly to provide cover for an emergency retreat.

Specifications

The M32 Tank Recovery Vehicle was an armored recovery vehicle based on the chassis of the M4 Sherman, adding an boom, an A-frame jib, and a winch. It was long, adding when the boom, which is used to lift damaged vehicles, was fully extended. The width was and the height was. It weighed either , or depending on the model. The engine varied between which variant of the M4 Sherman it was based upon, so the M32 and M32B1 model had a Continental R975-C1 or -C4 9 cylinder radial gasoline engine, running at 2,400 rpm, the M32B2 model had a General Motors 6046 twin diesel engine; running at 2,100 rpm, and the M32B3 model had a Ford GAA V8 gasoline engine running at 2,600 rpm. The engines varied depending on the variant of the M4 Sherman the vehicle was based on because M32s were based on the M4 Sherman. The range and fuel capacity varied between and respectively depending on the engine. However, top speed remained constant at.
It had a Spicer manual synchromesh transmission, with one reverse and five forward gears. The suspension was VVSS for earlier variants, and HVSS for variants demarcated with an A1. It had between of armor depending on location. It had an armament that consisted of an 81 mm mortar, which was used to cover emergency retreats, and a M2 Browning machine gun combined with a M1919 machine gun. There were 20 hand grenades, and six smoke grenades in the crew compartment. The armament was used only for self-defense, as the vehicle was not designed to be used as an offensive weapon.

Development history

In early 1942, the US Army began mobilizing and reequipping for war in Europe. Based on British combat experience from earlier in the war, the United States Ordnance Department determined that the army would need vehicles that could be used to recover armored vehicles that had been damaged in combat. The British had already developed several armored recovery vehicles based on the M4 Sherman such as the AVRE and the BARV; however, the Ordnance Department did not wish to use these variants and ordered several new ARV prototypes to be developed, also based on the M4 Sherman.
The basic prototypes of the M32 were created by Lima Locomotive on January 11, 1943. The prototypes were labeled T5, T5E1, T5E2, T5E3, and T5E4. These designs competed against the T2 and T7 designs, which both had a turret mounted boom, at the Aberdeen Proving Grounds. The T5 was declared superior to the T2 and T7 designs after several weeks of testing. The four prototypes were sent to Aberdeen, Camp Hood, and Camp Seely. However, during the testing the T5E3's engine was damaged, so it could not go through further testing. OCM 21553 standardized the designs of the T5, T5E1, T5E2, T5E3, and the T5E4 as the M32, M32E1, M32E2, M32E3, and the M32E4 in June 1943. This protocol also terminated the T7 project. However, the M32E4 did not enter production. Many M32s were converted into M34 Prime Movers, which were used to tow heavy artillery. The M34s were unarmed, and had special equipment to pull heavy artillery.

Production history

The production of the M32 was started by Lima Locomotive, which converted five M32B2s in June 1943. They also intermittently produced 26 M32B3s in May 1944, followed by 20 more vehicles in the summer of 1944. Pressed Steel Car produced 163 M32s and 475 M32B1s from December 1943 to December 1944. Pressed Steel Car also converted 298 M4A3 Shermans into M32B3s between May and December 1944. Baldwin Locomotive Works and Federal Machine were licensed to produce M32 variants in November 1944. Baldwin Locomotive Works produced 195 M32B1s before June 1945 and the latter produced 385 M32B1s before May of that year. In total, 1562 M32s were produced.

Service history

The M32 entered service with the US Army in July 1943. They served in the Italian Campaign, Operation Overlord, and many other battles in the European Theater of Operations. The A1 variants, which were converted by Baldwin Locomotive in 1945, also served until the end of the Korean War. The M74 Tank Recovery Vehicle replaced the M32B1A1s after the Korean War in 1954 after the production of heavier tanks such as the M46 Patton.
The M32 was considered inadequate for its role as an armored recovery vehicle, especially during the Korean War, because of the narrow tracks which gave the vehicle insufficient flotation to move over poor terrain such as mud and the power of the engine was insufficient to pull large tanks, such as the M26 Pershing. Some M32B1s were also shipped to Britain under Lend-Lease, where they were designated the ARV Mark III by the British Army. The Ordnance Department attempted to replace the M32 with the T12 Armored Recovery Vehicle in 1944 in M26 Pershing companies, but the T12 became too expensive, and so was never put on the production line. The M32 was also planned to have mine-exploding equipment, such as the T1E1 Earthworm and the T2E1 Mine Exploder. However, only the T1E1 had any service with the vehicle.
Several M32s were loaned to the Israeli Army in the late 1940s by the U.S. They saw service in the Suez Crisis, Six-Day War, and Yom Kippur War to tow M51 Super Shermans. Several M32s saw service in the Mexican Army under the nickname "Chenca" until 1998. The U.S. loaned Mexico these M32s shortly after World War II. Some M32 and M32Bs were also sent to Tito's Yugoslavia during the Informbiro period.

Variants