Mark IV tank


The Mark IV was a British tank of the First World War. Introduced in 1917, it benefited from significant developments of the Mark I tank. The main improvements were in armour, the re-siting of the fuel tank and ease of transport. A total of 1,220 Mk IV were built: 420 "Males", 595 "Females" and 205 Tank Tenders, which made it the most numerous British tank of the war. The Mark IV was first used in mid 1917 at the Battle of Messines Ridge. It remained in British service until the end of the war, and a small number served briefly with other combatants afterwards.

Development

The director of the Tank Supply Department, Albert Gerald Stern, first intended to fit the Mark IV with a new engine and transmission. Production of battle tanks was halted until the new design was ready, necessitating the use of the Mark II and III as interim training tanks. Failing to complete development soon enough to start production in time to have 200 tanks ready for the promised date of 1 April 1917, Stern was ultimately forced to take a Mark IV into production in May 1917 that was only slightly different from the Mark I tank.
The Mark IV Male initially carried three Lewis machine guns – one in the cab front and one in each sponson – and a QF 6 pdr 6 cwt gun in each sponson, with its barrel shortened as it had been found that the longer original was apt to strike obstacles or dig into the ground. The sponsons were not mirror images of each other, as their configuration differed to allow for the 6 pdr's gun-layer operating his gun from the left and the loader serving the gun from the right. The guns had a 100 degree arc of fire but only the starboard gun could fire straight ahead. The Female had five Lewis guns but no 6-pounders.
The decision to standardise on the Lewis gun was due to the space available within the tanks. Despite its vulnerable barrel and a tendency to overheat or foul after prolonged firing, the Lewis had the advantage that it used compact pan magazines which could hold up to 96 rounds. The Hotchkiss was fed from a rigid strip which was trimmed down to only 14 rounds for tank use; no sooner had the machine gunner guided the fall of shot onto the target than it was time to change the strip and the process repeated. It was not until a flexible 50 round strip was fully developed in May 1917 that the Hotchkiss would become the standard machine gun for tanks again. The changes caused delays, such as adapting the design for the bulky Lewis cooling barrel, and later, problems when the Hotchkiss strips had to be stored in positions designed for Lewis gun magazines.
At the Battle of Cambrai, Mark IV tanks were equipped with fascines, bundles of brushwood bound with chains, about long and in diameter carried on the roof of the cab. They were dropped into trenches to allow the tank to cross over more easily.
A large number of these tanks were also used for development work. In an attempt to improve trench-crossing capability, the tadpole tail, an extension to the rear track horns, was introduced. However, it proved insufficiently rigid and does not appear to have been used in combat. Other experimental versions tested radios, mortars placed between the rear horns, and recovery cranes. Some of these devices were later used on operational tanks. Mark IVs were also the first tanks fitted with unditching beams by field workshops. A large wooden beam, reinforced with sheet metal, was stored across the top of the tank on a set of parallel rails. If the tank became stuck, the beam was attached to the tracks and then dragged beneath the vehicle, providing grip.
The Mark IV was built by six manufacturers: Metropolitan, Fosters of Lincoln, Armstrong-Whitworth, Coventry Ordnance Works, William Beardmore and Company and Mirrlees, Watson & Co., with the main production being in 1917. The first order was placed for 1,000 tanks with Metropolitan in August 1916. It was then cancelled, reinstated and then modified between August and December 1916. The other manufacturers, contracted for no more than 100 tanks each, were largely immune to the conflict between Stern and the War Office.

Service

The Mark IV was first used in large numbers on 7 June 1917, during the British assault on Messines Ridge. Crossing dry but heavily cratered terrain, many of the 60-plus Mark IVs lagged behind the infantry, but several made important contributions to the battle. By comparison, at the Third Battle of Ypres from 31 July, where the preliminary 24-day long barrage had destroyed all drainage and heavy rain had soaked the field, the tanks found it heavy going and contributed little; those that sank into the swampy ground were immobilised and became easy targets for enemy artillery.
Nearly 460 Mark IV tanks were used during the Battle of Cambrai in November 1917, showing that a large concentration of tanks could quickly overcome even the most sophisticated trench systems.
In the aftermath of the German Spring Offensive on the western front, the first tank-to-tank battle was between Mk IV tanks and German A7Vs in the Second Battle of Villers-Bretonneux in April 1918.
About 40 captured Mark IVs were employed by the Germans as Beutepanzerwagen with a crew of 12. These formed four tank companies from December 1917. Some of these had their six pounders replaced by a German equivalent.
The last Mark IV to see service, briefly, was Excellent, a Mark IV male retained by the naval gunnery school on Whale Island, Hampshire, HMS Excellent. In 1940 it was restored to operational status and driven to the mainland, where its new career was allegedly brought to an early end after a number of cars were damaged.

Surviving vehicles

A local company, William Foster & Co., manufactured the first tanks, although as the only Mark IVs built in Lincoln were Male, this vehicle was probably built by Metropolitan in Birmingham. Recent research had put the identity of this tank into doubt, a partial serial number was found in 2014 that suggests this tank is not in fact Flirt II, as it was previously described.