The Moto GuzziLe Mans is a sports motorcycle first manufactured in 1976 by Italian company Moto Guzzi. It was named after the 24-hour motorcycle endurance race at Le Mans in France. The Le Mans designation was first used for an 850 prototype, based on the V7, displayed at Premio Varrone in late 1972. The original 850 Le Mans was a café racer with clip-on handlebars and a bikini nose fairing, but later models were developed as sports tourers with a three-quarter fairing. A marketing success, the Le Mans competed against Italian superbikes from Ducati and Laverda. The Le Mans spawned several successor models, a final version appearing in the late 1990s.
850 Le Mans
The Le Mans 850 café racer, or Le Mans Mark I, was first shown at the Milan motorcycle show in November 1975, and sales began in 1976. Like the 750S and the 750 S3, the Le Mans 850 was developed from the 53 hp V7 Sport model of 1971, but power was increased to 71 hp. The power output measured at the back wheel was 71 bhp, giving a top speed of 130 mph. Compared to its roadster sibling, the T3, the Le Mans had higher-compression domed pistons, larger engine valves, and Dell'Orto 36 mm pumper carbs with filterless velocity stacks. The Mark I had two production runs with slight modifications. The first run, Series 1, had a round CEV taillight and continued until at least September, 1976, but fewer than 2,000 of these were made. The Series 2 run totalled some 4,000 bikes and had these modifications: a De Tomaso-designed rectangular taillight, a modified rear mudguard, black fork sliders and a more generous dual seat. The seat was a one-piece item of injection-moulded foam. Most Le Mans 850 bikes were red and black, but a few were metallic blue, and even fewer were white. Le Mans bikes gained a reputation for poor frame paint and rusting exhausts. Le Mans bikes exported to the United States had yellow side reflectors on CEV indicators, and a sealed-beam headlight as the OEM Aprilia headlight did not meet Department of Transport approval. These US sealed-beam units protruded in an ungainly way, spoiling the profile of the bike.
850 Le Mans II
The Mark II was similar to the Mark I, but the small 'bikini" fairing became a larger full fairing, in three parts, incorporating indicators. The fairing had been tested in Moto Guzzi's wind tunnel. The new fairing had a rectangular headlight, rather than the earlier round item. Cylinder bores were not coated with Moto Guzzi's patented "Nikasil" until later. Front suspension became air-assisted. The brake calipers on the front wheel, previously mounted on the front, were now mounted behind the forks. The dualseat was the same and could carry a pillion. Further changes included a revised instrument cluster derived from the 1000cc SP. Brakes were linked, with the handlebar lever operating the front right caliper and the footbrake operating both the front left and rear caliper.
850 Le Mans III
The tank, seat, fairings were redesigned, and the instrument cluster was now dominated by a large white faced Veglia tachometer. An extensive technical re-design saw 80 changes from the Mk II model. Revised cylinder heads and barrels had a squared-off cooling-fin design. Pushrods were moved further from the bore centre, allowing for future increases in cylinder capacity. The engine had improved machining tolerances, revised carburation and exhaust systems, all of which gave an increase in power and torque. Minor changes were made to the rear suspension and to the front forks, with provision of linked air-assisted damping.
Le Mans 1000 1984–1993
The Le Mans 1000 appeared at the end of 1984 and continued with minor modifications until 1993. The two main production runs were known as Series 1 and Series 2. The Le Mans 1000 had a 949 cc engine with uprated 40 mm pumper carbs and the B10 camshaft from the production racer. De Tomaso himself decreed a 16-inch front wheel and new Lario-styling for the Le Mans 1000 Instead of redesigning the frame to incorporate a smaller front wheel, Guzzi simply fitted the smaller wheel into the existing frame without reconfiguring the geometry. Sturdier forks were fitted, as were smaller semi-floating front discs. The new bike was now physically much larger than the lean and low earlier Le Mans bikes, and performance was scarcely better than the Mark III predecessor. An 18-inch option became available in 1987. The Series 2 bikes included uprated Bitubo dampers and updated geometry. Most 1988 models were factory-fitted with the 18-inch wheel.
Le Mans 1000 SE (Special Edition) 1986–1988
Released to commemorate the 20th anniversary of the V7's appearance the 1000 SE was sold in late 1986, 1987, and also into 1988 for those in the US market. All 1000 SE bikes were red and white, with a red seat, red cast wheels and most had black rocker covers, engine and lower rails. Some had black engines and transmissions. The gearing was closer and higher than the standard 1000.
Le Mans 1000CI 1988–1993
The 1000CI included many updates of the previous version and included a range of color schemes. The Series 3 is sometimes called the Le Mans 1000 Mark V NT and was to be the final incarnation of the line of Moto Guzzi Le Mans models.
