Mueller Cloth Mill


The Mueller Cloth Mill, located in Euskirchen, North Rhine-Westphalia, Germany is a section of the LVR Museum of Industry. The museum provides insight into the production process of a cloth mill by showing fully working machinery and equipment from around 1900. Opened in 2000, the museum preserves the mill's state at its shutdown in 1961. LVR Industrial Museum Mueller Cloth Mill is an ‘Anchor Point’ of the European Route of Industrial Heritage and a central stop on the ‘Wool Route’.

History

The factory started life as a papermill in 1801. A few decades later things changed: in the mid-19th century the building was used to scour and spin wool and to full the cloth. From 1860 onwards the increasing demand of power supply lead to the installation of a new steam engine, which replaced the old mill wheel.
In 1894 Ludwig Mueller purchased the building and set up a cloth mill. The whole process of production was brought together under one roof. Like most other regional mills Mueller offered coarse woollen cloth, loden and uniform cloth. The machinery – bought in the years around 1900 – and the new steam engine from 1903 set the production on a firm basis. This equipment never happened to be altered until the final shut down. After Mueller's death in 1929, his son Kurt Mueller led the mill. In 1961, the mill was finally closed, due to lack of orders.

Museum

Despite the shutdown of the cloth mill, Kurt Mueller hoped to start production again one day. During the following years nothing happened in the mill. In 1988 the ‘Rheinisches Industriemuseum’ seized the opportunity and took over a completely fitted factory nearly untouched since the last day of work. The unique building, the machinery and thousands of small pieces of equipment were to be preserved. After careful stabilisation of the building and a comprehensive restoration the mill is providing an insight into the production of woolen cloth, into the different working processes and into the life of the workers. During guided tours through the mill, the old machinery from around 1900 is set in action.

The entire equipment and machinery was restored into conditions at the time of the closure of the factory in 1961. Therefore the ‘key machines’ running during guided tours had been restored to make them work properly like they did in 1961. Also disused machines and machines that are not in action nowadays were restored by preserving all traces of usage and improvisations to provide an authentic insight into the life of a cloth mill.