Norwich engine shed was adjacent to the station on the south side of the line. It was established in 1843 by the Yarmouth and Norwich Railway and was built and designed by William Marshall. By 1845 the shed was the centre of locomotive maintenance for the Norfolk Railway. By 1848 the site was under the auspices of the Eastern Counties Railway who further developed the site. The main shed consisted of four through roads one of which dealt with everyday repairs and an adjacent site that dealt with more serious repairs.
In 1914 the District Locomotive Superintendent was responsible for the shed which at this point employed 260 footplate staff with a further 50 at the various out stations such as Cromer, Mundesley, Sheringham, Dereham, Foulsham and Forncett. The DLS had a running shed foreman and two other foremen who looked after the sheds at Lowestoft and Yarmouth. In addition to the footplate staff there were 120 fitting staff who were under the control of another foreman. These staff were actually located in the adjacent "factory" building where the major repairs were carried out. Like many GER engine sheds a lot of facilities were very basic. Ash was dropped directly into an area known as the old yard where it was then shovelled into wagons. In the early days coal was unloaded from wagons onto a wooden stage and then loaded manually into the locomotive’s tender. It was not until 1915 that the GER supplied a shelter for this work to be carried out but it was not until the 1930s that a mechanised coal plant was supplied. At the end of 1922 the shed at Norwich had an allocation of 119 locomotives being the fourth biggest shed on the Great Eastern behind Stratford Cambridge and Ipswich sheds. The allocation consisted of:
Following the grouping Act of 1922 the LNER became responsible for the operation of the shed on 1 January 1923. A March 1936 LNER Locomotive Committee report notes that there were two turntables at Norwich - one a 55-foot diameter example located at the south end of the shed and the other with a diameter of 49 feet 8 inches being located close to Thorpe station. The report recommended replacement of one of these with a 70-foot turntable and also noted the shed was used by 300 engines each week in summer and 210 in winter. This bigger turntable was ordered in 1936 and fitted at the Carrow Road site. Modernization of the facilities in the 1930s saw rationalisation of the works site and general repairs ceased in 1934. The facilities of the old factory were still utilised by the engine shed for a number of years however.
British Railways 1948-1982
The service was coded 32A under British Railways this code being used to indicate which locomotives were allocated there. A plan of the shed in the 1950s shows:
During the final years of steam, responsibility for the operation of the shed fell to shedmaster Bill Harvey. The shed enjoyed a good reputation for its work on steam locomotives at this time. When diesel operation started a fuelling point was established on the east side of the line adjacent to Carrow Road bridge. In 1973 the TOPScomputer system Norwich's depot code changed to NO then later to NR. Before closure Norwich was home to a fleet of Class 03 and Class 08 shunters as well as the local DMU fleet which covered the local services and included examples of Class 105 Cravens Units and Class 101 Metropolitan Cammell units.
