ODOP


The ODOP radar tracking system is essentially the same as the UDOP system used for many years at the Atlantic Missile Range, but ODOP operates at different frequencies. It is a phase-coherent, multistation Doppler tracking system which measures position of a vehicle equipped with the ODOP transponder. ODOP stations are located at and around Cape Kennedy. The ODOP transponder is carried in the first stage of the Saturn vehicles and, therefore, ODOP tracking data is limited to the flight of the first stage only. The ODOP tracking system provides data immediately following lift-off while other tracking systems cannot "see" the vehicle or their accuracy is reduced by multipath propagation during the early phase of the flight.
The ODOP system is a radar interferometer tracking system which determines the position of a vehicle-borne transponder. The ground transmitter radiates a CW signal of 890 MHz to the transponder in the vehicle. The transponder shifts the received signal in frequency by 70 MHz and retransmits it to the receiving stations. The signal from the transponder received at the ground stations contains a 2-way Doppler shift fD which is extracted by mixing the received signal with the reference frequency derived from the transmitter frequency. Actually, a reference frequency of 53.33 MHz is transmitted over a VHF link to each transmitter station and then multiplied by a factor of 18, yielding 959.94 MHz. When this frequency is combined with the signal received from the transponder, the Doppler shift is obtained with a 60 kHz bias frequency. The UDOP system used a transmitter frequency of 450 MHz which was doubled in the transponder. The higher frequency in the ODOP system is less affected by the ionosphere and the result is increased tracking accuracy.
The Doppler frequencies, fD, from all receiving stations are transmitted to the central station and recorded on magnetic tape. Integration of the Doppler frequency received at a particular station provides the range sum, i.e., the distance transmitter-transponder receiver. At least three range sums are necessary to compute the position of the vehicle. The ODOP system uses 20 receiver stations around Cape Kennedy for redundancy and optimum tracking geometry. ODOP tracking data is not available in real time but is obtained from post-flight evaluation.

ODOP transponder

The ODOP transponder is a modified version of the transponder used by the Jet Propulsion Laboratory in the Ranger vehicles. Separate antennas are used for the receiver and the transmitter. The transponder consists of a double superheterodyne receiver and a transmitter. The signal transmitted from the transponder is phase-coherent with the signal received by the transponder. Phase coherence is accomplished by an automatic phase tracking loop. The transponder is completely transistorized.

ODOP system characteristics


Ground Transmitter:
------------------------
Frequency......................... 890 MHz
Transponder:
---------------
Receiver frequency …………….............. 890 MHz
Receiver noise figure.. ……………........ 14 db
Receiver threshold sensitivity...... -132 dbm
Predetection bandwidth …………........... 100 kHz
Threshold noise bandwidth……….......... 600 Hz
Strong signal noise bandwidth....... 1400 Hz
Transmitted frequency................. 960 MHz
Transmitter power...................... 1 watt
Required dc power..................... 36 watts
Weight............................. 10.25 kg
Size................................ 7370 cm 3
Ground Receiving Station:
-------------------------------
Receiver frequency............. 960 MHz