On-base percentage is calculable for professional teams dating back to the first year of National Association of Professional Base Ball Players competition in 1871, due to the component values of its formula being recorded in box scores of the time. However, the statistic was not conceptualized until sometime in the late 1940s by Brooklyn Dodgers team statistician Allan Roth, in consultation with then-Dodgers general managerBranch Rickey. In 1954, Rickey, who was then the general manager of the Pittsburgh Pirates, was featured in a Life Magazine graphic in which the formula for on-base percentage was shown as the first component of an all-encompassing "offense" equation. However, it was not named as on-base percentage, and there is little evidence that Roth's statistic was taken seriously at the time by the baseball community at large. On-base percentage became an official MLB statistic in 1984. Since then, especially since the publication of the influential 2003 bookMoneyball which prominently highlighted Oakland Athletics general manager Billy Beane's focus on the statistic, on-base percentage has seen its perceived importance as a measure of offensive success increase dramatically. Many baseball observers, particularly those influenced by the field of sabermetrics, now consider on-base percentage to be superior to the traditional statistic meant to measure offensive skill, batting average. This is most notably because while both statistics incorporate a batter's success in recording hits, batting average ignores, while on-base percentage incorporates, the rate at which a batter is also able to avoid making an out and reach base via bases on balls or "walks."
Overview
Traditionally, players with the best on-base percentages bat as leadoff hitter, unless they are power hitters, who traditionally bat slightly lower in the batting order. The league average for on-base percentage in Major League Baseball has varied considerably over time; at its peak in the late 1990s, it was around.340, whereas it was typically.300 during the dead-ball era. On-base percentage can also vary quite considerably from player to player. The highest career OBP of a batter with more than 3,000 plate appearances is.482 by Ted Williams. The lowest is by Bill Bergen, who had an OBP of.194. On-base percentage is calculated using this formula: where
In certain unofficial calculations, the denominator is simplified and replaced by Plate Appearance ; however, the calculation PAs includes certain infrequent events that will slightly lower the calculated OBP. Sacrifice bunts are excluded from consideration on the basis that they are usually imposed by the manager with the expectation that the batter will not reach base, and thus do not accurately reflect the batter's ability to reach base when attempting to do so.
