OECTs consist of a semiconductor film, usually made of a conjugated polymer, which is in direct contact with an electrolyte. Source and drain electrodes establish electrical contact to the channel, while a gate electrode establishes electrical contact to the electrolyte. The electrolyte can be liquid, gel, or solid. In the most common biasing configuration, the source is grounded and a voltage is applied to the drain. This causes a current to flow, due to electronic charge present in the channel. When a voltage is applied to the gate, ions from the electrolyte are injected in the channel and change the electronic charge density, and hence the drain current. When the gate voltage is removed, the injected ions return to the electrolyte and the drain current goes back to its original value. OECTs are different from electrolyte-gated field-effect transistors. In the latter type of device, ions do not penetrate into the channel, but rather accumulate near its surface. This induces accumulation of electronic charge inside the channel, near the surface. In contrast, in OECTs, ions are injected into the channel and change the electronic charge density throughout its entire volume. As a result of this bulk coupling between ionic and electronic charge, OECTs show a very high transconductance. The disadvantage of OECTs is that they are slow, as ionic charge has to get in and out of the channel. Microfabricated OECTs show response times of the order of hundreds of microseconds. The most common OECTs are based on, and work in the depletion mode. In this material, the :Organic semiconductor|organic semiconductor PEDOT is doped :Extrinsic semiconductor|p-type by the sulfonate anions of the PSS and hence exhibits a high conductivity. Hence, in the absence of a gate voltage, the drain current will be high and the transistor will be in the ON state. When a positive voltage is applied to the gate, cations from the electrolyte are injected into the PEDOT:PSS channel, where they compensate the sulfonate anions. This leads to dedoping of the PEDOT, and the transistor reaches its OFF state. Accumulation mode OECTs, based on intrinsicorganic semiconductors, have also been described. Accurate simulation of OECTs is possible using the drift-diffusion model. OECTs were first developed in the 80’s by the group of Mark Wrighton. They are currently the focus of intense development for applications in :Bioelectronics|bioelectronics, and in large-area, low-cost :electronics|electronics. Advantages such as straightforward fabrication and miniaturization, compatibility with low-cost printing techniques, compatibility with a wide range of mechanical supports, and stability in aqueous environments, led to their use in a variety of applications in biosensors. Moreover, their high transconductance makes OECTs powerful amplifying transducers. OECTs have been used to detect :ion|ions, :Metabolite|metabolites, :DNA|DNA, :Pathogen|pathogenic organisms, probe :Cell adhesion|cell adhesion, measure the integrity of barrier tissue, detect :Epilepsy|epileptic activity in rats, and interface with electrically active cells and tissues.
