Praga V3S


The Praga V3S is an all-terrain multi-purpose truck, produced since 1953 in Czechoslovakia, it was especially designed for the armed forces and was also exported to 72 countries. Praga produced the truck until 1964, then Avia company till around 1986, after which the Bratislava company BAZ rolled out these vehicles till 1990. Around 130 000 units were manufactured. The truck was among the best off-road cargo vehicles of its time and the Czechoslovak Army used it for more than half a century. It was the longest produced Czechoslovak truck.

Development

For the development till prototype stage of the truck, designers were given only four months, they were inspired mainly by the American Studebaker US6 and Russian ZiL. Due to the design of axle gearboxes, the V3S has a high ground clearance, this structure provides great terrain passability, but on the other hand limits the maximum speed. The V3S was a durable, popular and extremely adaptable truck built in various versions and widely exported, therefore it is not difficult to see V3S based vehicles still hard at work nowadays.

Description

The engine is an air-cooled diesel six-cylinder "Tatra 912-1", with a capacity of 7412 cm³, direct fuel injection and overhead valves. It is relatively noisy, but works reliably even in extreme conditions. Climbing ability is up to 75%. Ten wheels help the truck not to bog down in soft soil, therefore it does not experience any problems in forests or in the field. Consumption is 30 liters of diesel per 100 km, the fuel tank has a capacity of 120 liters. The truck is able to get over 40 cm high perpendicular obstacle, wading depth is 80 cm. There are two batteries, they connected in parallel during traffic, but serially when engine starts. The payload of the truck is 5 tons on paved surfaces and 3 tons on rough terrain. Maximum speed is.

Images