A Primary radar is a conventional radar sensor that illuminates a large portion of space with an electromagnetic wave and receives back the reflected waves from targets within that space. The term thus refers to a radar system used to detect and localize potentially non-cooperative targets. It is specific to the field of air traffic control where it is opposed to the secondary radar which receives additional information from the target's transponder. This type of radar uses low vertical resolution antenna but good horizontal resolution. It quickly scans 360 degrees around the site on a single elevation angle. It can thus give the distance and radial speed of the target with good precision but requires often one or more radars to obtain the vertical position and the actual speed. The advantages of the primary radar are no on-board equipment in the aircraft is necessary for detecting the target and can be used to monitor the movement of vehicles on the ground. The disadvantages are that the target and altitude can not be identified directly. In addition, it requires powerful emissions which limits its scope.
Description
Primary radar operation is based on the principle of echolocation. Electromagnetic pulses of high power emitted by the radar antenna are converted into a narrow wavefront which propagates at the speed of light. This is reflected by the aircraft and then picked up again by the rotating antenna on its own axis. A primary radar detects all aircraft without selection, regardless of whether or not they possess a transponder. The operator hears the echoes from any reflection. Therefore, it performs transmission/listening continuously, which covers the space 360 °. The primary radar functions, therefore, results in detection and measurements of position if there is the presence of a target by the recognition of the useful signal. A primary radar measurement include:
It can be said that a radar locates a flying object on a quarter circle in the vertical plane, but cannot know exactly its altitude if it is using a fan-beam antenna. This information must be obtained by triangulation of several radars in that case. However, with a 3D radar this data is obtain by using either a cosecant squared pattern or a scanning on multiple angles with a pencil beam.
Usage
The rapid wartime development of radar had obvious applications for air traffic control as a means of providing continuous surveillance of air traffic disposition. Precise knowledge of the positions of aircraft would permit a reduction in the normal procedural separation standards, which in turn promised considerable increases in the efficiency of the airways system. This type of radar can detect and report the position of anything that reflects its transmitted radio signals including, depending on its design, aircraft, birds, weather and land features. For air traffic control purposes this is both an advantage and a disadvantage. Its targets do not have to co-operate, they only have to be within its coverage and be able to reflect radio waves, but it only indicates the position of the targets, it does not identify them. When primary radar was the only type of radar available, the correlation of individual radar returns with specific aircraft typically was achieved by the controller observing a directed turn by the aircraft. Primary radar is still used by ATC today as a backup/complementary system to secondary radar, although its coverage and information is more limited.
