Prussian P 8


The Prussian Class P 8 of the Prussian state railways was a 4-6-0 steam locomotive built from 1906 to 1923 by the Berliner Maschinenbau and twelve other German factories. The design was created by Robert Garbe. It was intended as a successor to the Prussian P 6, which was regarded as unsatisfactory.

Construction

Because Garbe was an advocate of the simplest possible designs, a straightforward, superheated steam, two-cylinder driving gear was envisaged. The P 8 benefited especially from superheated steam technology, which had just been developed by Wilhelm Schmidt, that led to outstanding performance for those times. The P 8 was a very economical locomotive that did not make great demands on the ability of the engine driver. At the outset Garbe even designed the P 8 as an express train locomotive, with the expectation of attaining a top speed of. As a result, the first units were fitted with low-wind-resistance, tapered driver's cabs.
The enthusiasm of crews for the new locomotive was at first muted. The boiler was very effective at evaporation, however against that there were numerous teething troubles, e.g. the driving rod bearings were too small. This led continually to overheating. The loosely coupled Prussian box tender led to disturbing riding qualities when running tender-first. Its riding performance was never fully satisfactory. As a result of poor weight compensation, the top speed estimated by Garbe was never achieved and it was eventually assessed at 100 km/h.
One characteristic feature of the P 8 is the large distance between the centre and rear coupled axles. At the outset the P 8 only had a steam dome behind the sandbox; later a forward feed dome was added. Further constructional changes affected, inter alia, the driver's cab roofs, the smoke deflectors and various external assemblies.
There would appear to have been a number of boiler variations. The following combinations can be seen in photographs:
1/. boiler feeds on sides on boiler, steam dome in front of sandbox
2/. boiler feeds on sides of boiler, steam dome behind sandbox
3/. boiler feeds on top of boiler without feed dome, steam dome behind sandbox
4/. boiler feeds on top of boiler with feed dome, steam dome behind sandbox
At least some of very early engines carried type boilers and this type appears to have been the standard in the early years. Types and do not seem to have appeared until after World War I but ultimately became prevalent. See "100 Jahre Preussische P8".
In order to be able to turn the locomotive even on small turntables, the Prussian state railways fitted the P 8 with tenders that originally held 21.5 m³ of water and 7 t of coal. Later the Deutsche Bundesbahn coupled the Class 38 with the tenders of withdrawn wartime locomotives the so-called 'Kriegslokomotiven', especially the bathtub tenders, which could carry more fuel. In addition the top speed when running tender-first was increased from to.
On the other hand, the Deutsche Reichsbahn also used tenders of DRG Class 17 steam locomotives that had been taken out of service. These were the so-called long-distance tenders.

Employment

The P 8 could haul 300 t at and 400 t at on the flat and, after the world wars, could be found in almost the whole of Europe. The order to build the first 10 machines was issued to the firm of Schwartzkopff in 1906. With up to 14 express coaches attached, the trial runs went brilliantly. The first engine of this, soon internationally famous, class was placed into service in the Lower Rhine with the number "Coeln 2401".
The P 8 could be used for a variety of duties and was found in heavy express train and goods train services heading almost every train. Even the railway authorities were very pleased with these engines, because the last P 8 locomotives were not mustered out by the Deutsche Reichsbahn until 1972, and by Deutsche Bundesbahn until 1974. More than 500 P 8 engines were in service for 50 years.
The majority of the P 8 class engines were built by Schwartzkopff who produced 1025 units, followed by Henschel in Kassel with 742 units. Besides the Prussian state railways, the Grand Duchy of Oldenburg State Railways also bought five and the Grand Duchy of Mecklenburg Friedrich-Franz Railway 13 machines. All German locomotive manufacturers later built Class P 8 locomotives including Hartmann and Esslingen.

P 8 Locomotives in the Baden State Railways

In order to compensate for the shortage of locomotives after the First World War as a result of ceasefire reparations and the large number of damaged locomotives, the Karlsruhe railway division reproduced 40 Prussian P 8 engines at the Maschinenbau-Gesellschaft Karlsruhe. They were stationed in Villingen, Mannheim and Karlsruhe, and were given running numbers 1153 to 1192. Under the Deutsche Reichsbahn they were renumbered as 38 3793 to 38 3832 in 1925.

P 8 Locomotives in other countries

In total 3,556 or 3,561 locomotives, were built for German states in 1906–1923, including 60 or 65 for occupation World War I service in Warsaw and Brussels. Of these, 627 had to be transferred to the victorious powers as reparations after the end of the First World War: Poland received 192, Belgium 168, France 162, Italy 25, Romania 18, Lithuania 11 and Greece 10 locomotives as SEK class Ζδ. 41 locomotives were ceded to Saar railways. Up to 1923, the newly founded Deutsche Reichsbahn replenished the fleet of P 8 locos with new machines, and possessed 2933 machines in total, numbered 38 1001 to 3832 and 38 3951 to 4051. In addition to 3,556 or 3,561 produced for the German railways, 65 new locomotives were produced for Poland in 1922–1923, and 95 for Romania, in 1921–1930. Further 226 locomotives were licence-manufactured in Romania in 1932-1939.
A total of 3,948 P 8 locomotives were built, which makes it the most numerous passenger train locomotive ever to be built in the world.
After the Second World War, numbers 38 1069, 1391, 1434, 1677, 1809, 1818, 2052, 2692, 3264, 3495 und 3525 remained in Austria. Number 38 2052 was returned to the Deutsche Bundesbahn in 1952. Locomotives 38 1391, 1434, 1818, 3495 and 3525 went to the Soviet Union. The remaining machines formed the Austrian ÖBB Class 638. In 2004, the Austrian Society for Railway History acquired two machines of this type from Romania, one of which carries out steam 'specials' under the fictitious number of ÖBB 638.1301. Polish locomotives Ok1 were taken over by the Germany during World War II, but along with new reparations, Poland received 429 of former P 8 engines after the war, used in line service until 1981.
Three of the class were impounded by British forces after World War II in Norway. They were sent to Copenhagen for repair and eventually were purchased by the Danish State Railways where they became DSB class T numbered 297, 298 & 299. The last survivor was scrapped in 1973.

France

In France, the 162 locomotives received as reparations were divided between five railways:
During World War II, many of the French P 8 locomotives were taken away by the German authorities, and while most returned, some were lost to East Germany and Poland. After the war, the SNCF decided to concentrate their P 8 locomotives on the Région Est. The État and its successor the Région Ouest had hated its former German locomotives, and withdrawn them as quickly as possible. Consequently, only 3-230.E.943 was still in service in 1946 when it was transferred to Région Est as 1-230.F.343. Of the former Midi locomotives, only 4-230.H.714 did not survive until 1946, when the remaining 19 became 1-230.F.401 to 1-230.F.420. In addition four German locomotives were discovered in France after the war, and these became 1-230.F.600 to 1-230.F.694; later 1-230.F.601 to 1-230.F.604.
Between 1948 and 1950, Région Nord had lent nine locomotives to Luxembourg as CFL 3902–3910. Four of these, along with 9 others were transferred to Région Est in 1950, where they became 1-230.F.210 to 1-230.F.272. The Nord had made extensive use of its P 8s and retained as may as it could. The last P 8 on Région Nord was retired in 1962, and the last on Région Est in 1966.

Preserved P 8 Locomotives

As early as the end of the 1930s the Deutsche Reichsbahn planned to replace the now ageing P8 by a new locomotive. This led to the development of the DRG Class 23, of which only 2 examples had been built, however, by 1941. In 1950 the Deutsche Bundesbahn began to use the more advanced DB Class 23 as a replacement for the P8. The factories produced 105 examples by 1951. The change of motive power meant that the last Class 23 was withdrawn by the DB only one year after the last P8 had been retired.