The Quadruplex telegraph is a type of electrical telegraph which allows a total of four separate signals to be transmitted and received on a single wire at the same time. Quadruplex telegraphy thus implements a form of multiplexing. The technology was invented by American inventorThomas Edison, who sold the rights to Western Union in 1874 for the sum of $10,000. The problem of sending two signals simultaneously in opposite directions on the same wire had been solved previously by Julius Wilhelm Gintl and improved to commercial viability by J. B. Stearns; Edison added the ability to double the number in each direction. The method combined a diplex, that Edison had previously invented, with a Stearns style Duplex. In each case, a clever trick is used. Since telegraphs use a single wire, the current must flow through the signal relay on both ends. For the Duplex, the challenge is simply to not have the local signal relay clack when the key is pressed but to clack when the remote is pressed. This is achieved by dividing the relay into two solenoid windings and feeding the local key's energizing voltage into the midpoint of these. Thus when the local key is pressed, the current divides equally in two directions. One of these goes through a relay coil then into a matched termination load. The other half of the current is sent down the wire to the remote relay and its termination load. Since the current flowing into this Y-shaped junction between the solenoids flows in opposite directions in the two local solenoids they sum to no net magnetic field and the local relay is not activated. At the remote end, the sent current flows through both solenoids in the same direction and into the termination load. Since current flows the same way in both solenoids the remote signal relay is activated by this local key. For the Diplex, a different trick is used. To send two messages simultaneously, one has two independent local telegraph keys. These are arranged so the battery is reversed in polarity on one of these. First note the challenge to overcome: the duplex solenoid as described above would not resolve which way the current is flowing. While the solenoid's magnetic field would be in the opposite direction, the induced ferromagnet in the iron bar would be attracted either way, closing the signal relay regardless of the current flow direction. The solution is to replace the iron with a permanent magnet, and the relay switch is replaced with a double pole switch. Now the permanent magnet senses the field direction and is pushed or pulled. When the permanent magnet north is repelled, the switch closes to one pole, and when the permanent magnet south is repelled the switch closes to the other pole. To make it practical, Edison found some additional relays were necessary to provide hysteresis that prevented the switch from being in-determinant or fluttering at the moment of current reversals and to send the separated signal to the appropriate sound emitter.
Innovations
While this is conceptually elementary to modern engineers, one has to appreciate that multiplexing was a patent-worthy breakthrough and a huge economic win for telegraphy since most of the challenge and expense was in the long wires between stations. This sort of polarity based diplexing is analogous to the modern so-called "Charlieplexing" often used in LED panels: there the diode nature of LEDs allows two different LEDs connected to ground to be controlled with the same wire depending on the voltage polarity. Edison and Stearns were dealing with the limited electronic components of the day. Stearn's innovation was to use a capacitor in the termination load. Without this only short transmission distances were possible because the impedance mismatch of the reactive long wire would not balance the currents in the two halves of the local relay, activating it. This was innovative since impedance matching for transmission lines instead of a simple ohmic circuits was not appreciated initially. This was technologically advanced because capacitors at the time were hard to make. Edison's innovations were the use of a polarized permanent magnet relay and the use of some ancillary relay logic to add a useful hysterisis to avoid the indeterminate current reversal states. The method of combining the diplex and the duplex Edison developed enabled the Quadruplex.
