Quantum simulators permit the study of quantum systems that are difficult to study in the laboratory and impossible to model with a supercomputer. In this instance, simulators are special purpose devices designed to provide insight about specific physics problems. Quantum simulators may be contrasted with generally programmable "digital" quantum computers, which would be capable of solving a wider class of quantum problems. A universal quantum simulator is a quantum computer proposed by Yuri Manin in 1980 and Richard Feynman in 1982. Feynman showed that a classical Turing machine would experience an exponential slowdown when simulating quantum phenomena, while his hypothetical universal quantum simulator would not. David Deutsch in 1985, took the ideas further and described a universal quantum computer. In 1996, Seth Lloyd showed that a standard quantum computer can be programmed to simulate any local quantum system efficiently. A quantum system of many particles is described by a Hilbert space whose dimension is exponentially large in the number of particles. Therefore, the obvious approach to simulate such a system requires exponential time on a classical computer. However, it is conceivable that a quantum system of many particles could be simulated by a quantum computer using a number of quantum bits similar to the number of particles in the original system. As shown by Lloyd, this is true for a class of quantum systems known as local quantum systems. This has been extended to much larger classes of quantum systems. Quantum simulators have been realized on a number of experimental platforms, including systems of ultracold quantum gases, polar molecules, trapped ions, photonic systems, quantum dots, and superconducting circuits.
Solving physics problems
Many important problems in physics, especially low-temperature physics and many-body physics, remain poorly understood because the underlying quantum mechanics is vastly complex. Conventional computers, including supercomputers, are inadequate for simulating quantum systems with as few as 30 particles. Better computational tools are needed to understand and rationally design materials whose properties are believed to depend on the collective quantum behavior of hundreds of particles. Quantum simulators provide an alternative route to understanding the properties of these systems. These simulators create clean realizations of specific systems of interest, which allows precise realizations of their properties. Precise control over and broad tunability of parameters of the system allows the influence of various parameters to be cleanly disentangled. Quantum simulators can solve problems which are difficult to simulate on classical computers because they directly exploit quantum properties of real particles. In particular, they exploit a property of quantum mechanics called superposition, wherein a quantum particle is made to be in two distinct states at the same time, for example, aligned and anti-aligned with an external magnetic field. Crucially, simulators also take advantage of a second quantum property called entanglement, allowing the behavior of even physically well separated particles to be correlated.
Trapped-Ion Simulators
A trapped-ion simulator, built by a team that included the NIST and reported in April 2012, can engineer and control interactions among hundreds of quantum bits. Previous endeavors were unable to go beyond 30 quantum bits. As described in the scientific journal Nature, the capability of this simulator is 10 times more than previous devices. Also, it has passed a series of important benchmarking tests that indicate a capability to solve problems in material science that are impossible to model on conventional computers. The trapped-ion simulator consists of a tiny, single-plane crystal of hundreds of beryllium ions, less than 1 millimeter in diameter, hovering inside a device called a Penning trap. The outermost electron of each ion acts as a tiny quantum magnet and is used as a qubit, the quantum equivalent of a “1” or a “0” in a conventional computer. In the benchmarking experiment, physicists used laser beams to cool the ions to near absolute zero. Carefully timed microwave and laser pulses then caused the qubits to interact, mimicking the quantum behavior of materials otherwise very difficult to study in the laboratory. Although the two systems may outwardly appear dissimilar, their behavior is engineered to be mathematically identical. In this way, simulators allow researchers to vary parameters that couldn’t be changed in natural solids, such as atomic lattice spacing and geometry. Friedenauer et al., adiabatically manipulated 2 spins, showing their separation into ferromagnetic and antiferromagnetic states. Kim et al., extended the trapped ion quantum simulator to 3 spins, with global antiferromagnetic Ising interactions featuring frustration and showing the link between frustration and entanglement and Islam et al., used adiabatic quantum simulation to demonstrate the sharpening of a phase transition between paramagnetic and ferromagnetic ordering as the number of spins increased from 2 to 9. Barreiro et al. created a digital quantum simulator of interacting spins with up to 5 trapped ions by coupling to an open reservoir and Lanyon et al. demonstrated digital quantum simulation with up to 6 ions. Islam, et al., demonstrated adiabatic quantum simulation of the transverse Ising model with variable range interactions with up to 18 trapped ion spins, showing control of the level of spin frustration by adjusting the antiferromagnetic interaction range. Britton, et al. from NIST has experimentally benchmarked Ising interactions in a system of hundreds of qubits for studies of quantum magnetism. Pagano, et al., reported a new cryogenic ion trapping system designed for long time storage of large ion chains demonstrating coherent one and two-qubit operations for chains of up to 44 ions.
Ultracold Atom Simulators
Many ultracold atom experiments are examples of quantum simulators. These include experiments studying bosons or fermions in optical lattices, the unitary Fermi gas, Rydberg atom arrays in optical tweezers. A common thread for these experiments is the capability of realizing generic Hamiltonians, such as the Hubbard or transverse-field Ising Hamiltonian. Major aims of these experiments include identifying low-temperature phases or tracking out-of-equilibrium dynamics for various models, problems which are theoretically and numerically intractable. Other experiments have realized condensed matter models in regimes which are difficult or impossible to realize with conventional materials, such as the Haldane model and the Harper-Hofstadter model.
