RAF-2203


The RAF-2203 Latvija was a cabover van designed and developed by Rīgas Autobusu Fabrika from 1976–1997. They were widely used throughout the USSR as fixed-run taxis, medical cars, used for trade and as a special services vehicles. It was the successor of the RAF-977.
This van used the engine of the GAZ-24, between the front seats, with independent front suspension also from the GAZ-24. It borrowed headlights and brake system parts from the Moskvitch 412, outside door handles from the Moskvitch 408, and wheels of the GAZ-21 Volga. The single rear door hinged at the top, rather than the more-usual side-opening. There were two major models: one, the 2203, seated ten plus driver and passenger, powered by a with 8.2:1 compression; the other, the 22032, a twelve-seat "route taxi", had longitudinal seats and lower 6.7:1 compression, and produced only.. An ambulance, the 22031, was soon added to the range, and made up fully a third of all 2203s built; there was also a 22035 for blood donor clinics. These were joined by the 22034, for fire departments.
In addition to the uncommon 22033 and 22036 for state militias, there were prototype electric vehicles.
While the 2203 looked good, it was susceptible to rust, especially in the frame rails, and was unpleasant to drive in bad weather. Quality control of the assembly was also poor. Oil leaks and axle bearing failures were frequent. It also suffered overheating, serious vibration issues, failures of front suspension parts leading to poor handling, and high fuel consumption. On top of it all, access to the cab was difficult, despite the forward-control position.
They have now been replaced mostly by GAZ products.

Variants