Richmond Union Passenger Railway


The Richmond Union Passenger Railway, in Richmond, Virginia, was the first practical electric trolley system, and set the pattern for most subsequent electric trolley systems around the world. It is an IEEE milestone in engineering.
The Richmond system was not the first attempt to operate an electric trolley. According to the IEEE, there were at least 74 earlier attempts to provide electric trolley service in over 60 communities in North America, the United Kingdom, and continental Europe. However, these earlier attempts were not reliable enough to replace the existing animal-hauled street railways.
The Richmond system was designed by Frank Julian Sprague. After trials in late 1887, it began regular operation on February 2, 1888, with 10 streetcars. Electric power was supplied through overhead trolley wires for two motors on each car. Large cars weighed, provided 40 seats, and carried up to 100 passengers; small cars weighed with 22 seats and up to 65 passengers. Running speed was, with as a maximum speed. By June 1888 the system contained 40 cars running on some of track, including steep grades, and with 30 degree or minimum radius curves.
Its success proved that electric traction was both safe and reliable. The Boston City Council, after inspecting Richmond's system on September 7, 1888, approved construction the second such project by the West End Street Railway. Boston's trolley was closely patterned upon Richmond's, and again demonstrated its practicality. By 1895 almost 900 electric street railways and nearly of track had been built in the United States, and in a little over a decade animal-powered street railways had essentially vanished.
Richmond's electric trolley service ended on November 25, 1949. It would not be until 2018 that the city would once again be served by rapid transit, when the GRTC Pulse opened.

Location