Rogue access point


A rogue access point is a wireless access point that has been installed on a secure network without explicit authorization from a local network administrator, whether added by a well-meaning employee or by a malicious attacker.

Dangers

Although it is technically easy for a well-meaning employee to install a "soft access point" or an inexpensive wireless router—perhaps to make access from mobile devices easier—it is likely that they will configure this as "open", or with poor security, and potentially allow access to unauthorized parties.
If an attacker installs an access point they are able to run various types of vulnerability scanners, and rather than having to be physically inside the organization, can attack remotely—perhaps from a reception area, adjacent building, car park, or with a high gain antenna, even from several miles away.

Prevention and detection

To prevent the installation of rogue access points, organizations can install wireless intrusion prevention systems to monitor the radio spectrum for unauthorized access points.
Presence of a large number of wireless access points can be sensed in airspace of a typical enterprise facility. These include managed access points in the secure network plus access points in the neighborhood. A wireless intrusion prevention system facilitates the job of auditing these access points on a continuous basis to learn whether there are any rogue access points among them.
In order to detect rogue access points, two conditions need to be tested:
  1. whether or not the access point is in the managed access point list
  2. whether or not it is connected to the secure network
The first of the above two conditions is easy to test—compare wireless MAC address Need to cover different types of access point devices such as bridging, NAT necessity to determine access point connectivity with acceptable response time in large networks, and c) requirement to avoid both false positives and negatives which are described below.
False positives occur when the wireless intrusion prevention system detects an access point not actually connected to the secure network as wired rogue. Frequent false positives result in wastage of administrative bandwidth spent in chasing them. Possibility of false positives also creates hindrance to enabling automated blocking of wired rogues due to the fear of blocking friendly neighborhood access point.
False negatives occur when the wireless intrusion prevention system fails to detect an access point actually connected to the secure network as wired rogue. False negatives result in security holes.
If an unauthorized access point is found connected to the secure network, it is the rogue access point of the first kind. On the other hand, if the unauthorized access point is found not connected to the secure network, it is an external access point. Among the external access points, if any is found to be mischievous or a potential risk, it is tagged as a rogue access point of the second kind, which is often called an "evil twin".

Soft access point

A "soft access point" can be set up on a Wi-Fi adapter using for example Windows' virtual Wi-Fi or Intel's My WiFi. This makes it possible, without the need of a physical Wi-Fi router, to share the wired network access of one computer with wireless clients connected to that soft AP. If an employee sets up such a soft AP on their machine without coordinating with the IT department and shares the corporate network through it, then this soft AP becomes a rogue AP.