"Tar" and "pitch" can be used interchangeably; asphalt may also be called either "mineral tar" or "mineral pitch". There is a tendency to use "tar" for more liquid substances and "pitch" for more solid substances. Both "tar" and "pitch" are applied to viscous forms of asphalt, such as the asphalt found in naturally occurring tar pits . "Rangoon tar", also known as "Burmese oil" or "Burmese naphtha", is also a form of petroleum. Oil sands, almost exclusively produced in Alberta, Canada, are colloquially referred to as "tar sands" but are in fact composed of asphalt, also called bitumen.
Wood tar
In Northern Europe, the word "tar" refers primarily to a substance that is derivedfrom the wood and roots of pine. In earlier times it was often used as a water repellent coating for boats, ships, and roofs. It is still used as an additive in the flavoring of candy, alcohol, and other foods. Wood tar is microbicidal. Producing tar from wood was known in ancient Greece and has probably been used in Scandinavia since the Iron Age. Production and trade in pine-derived tar was a major contributor in the economies of Northern Europe and Colonial America. Its main use was in preserving wooden sailing vessels against rot. For centuries, dating back at least to the 14th century, tar was among Sweden's most important exports. Sweden exported 13,000 barrels of tar in 1615 and 227,000 barrels in the peak year of 1863. The largest user was the Royal Navy of the United Kingdom. Demand for tar declined with the advent of iron and steel ships. Production nearly stopped in the early 20th century, when other chemicals replaced tar, and wooden ships were replaced by steel ships. Traditional wooden boats are still sometimes tarred. The heating of pine wood causes tar and pitch to drip away from the wood and leave behind charcoal. Birch bark is used to make particularly fine tar, known as "Russian oil", suitable for leather protection. The by-products of wood tar are turpentine and charcoal. When deciduous tree woods are subjected to destructive distillation, the products are methanol and charcoal. Tar kilns are dry distillation ovens, historically used in Scandinavia for producing tar from wood. They were built close to the forest, from limestone or from more primitive holes in the ground. The bottom is sloped into an outlet hole to allow the tar to pour out. The wood is split into dimensions of a finger, stacked densely, and finally covered tight with dirt and moss. If oxygen can enter, the wood might catch fire, and the production would be ruined. On top of this, a fire is stacked and lit. After a few hours, the tar starts to pour out and continues to do so for a few days.
Uses
Tar was used as seal for roofing shingles and tar paper and to seal the hulls of ships and boats. For millennia, wood tar was used to waterproof sails and boats, but today, sails made from inherently waterproof synthetic substances have reduced the demand for tar. Wood tar is still used to seal traditional wooden boats and the roofs of historic, shingle-roofed churches, as well as painting exterior walls of log buildings. Tar is also a general disinfectant. Pine tar oil, or wood tar oil, is used for the surface treatment of wooden shingle roofs, boats, buckets, and tubs and in the medicine, soap, and rubber industries. Pine tar has good penetration on the rough wood. An old wood tar oil recipe for the treatment of wood is one-third each genuine wood tar, balsam turpentine, and boiled or raw linseed oil or Chinese tung oil. In Finland, wood tar was once considered a panacea reputed to heal "even those cut in twain through their midriff". A Finnish proverb states that "if sauna, vodka and tar won't help, the disease is fatal." Wood tar is used in traditional Finnish medicine because of its microbicidal properties. Wood tar is also available diluted as tar water, which has numerous uses:
As a flavoring for candies and alcohol.
As a spice for food, like meat.
As a scent for saunas. Tar water is mixed into water, which is turned into steam in the sauna.
Mixing tar with linseed oilvarnish produces tar paint. Tar paint has a translucent brownish hue and can be used to saturate and tone wood and protect it from weather. Tar paint can also be toned with various pigments, producing translucent colors and preserving the wood texture. Tar was once used for public humiliation, known as tarring and feathering. By pouring hot wood tar onto somebody's bare skin and waiting for it to cool, they would remain stuck in one position. From there, people would attach feathers to the tar, which would remain stuck on the tarred person for the duration of the punishment. That person would then become a public example for the rest of the day. It was quickly abandoned due to the temporary and permanent physical damage caused by the burns of the tar from the application, which left those tarred scarred for life from the burns.
The use of tar dates back to 9th-century Baghdad, which had streets paved with tar, derived from petroleum that became accessible from natural fields in the region.
