U-NII
The Unlicensed National Information Infrastructure radio band is part of the radio frequency spectrum used by IEEE 802.11a devices and by many wireless ISPs. It operates over four ranges:
- U-NII Low : 5.150–5.250 GHz. Originally limited to indoor use only. Regulations required use of an integrated antenna, with power limited to 50 mW. Rules changed in 2014 to permit outdoor operation, maximum fixed power 1 watt, maximum fixed EIRP 4 watts point-to-multipoint, 200 watts point-to-point. However, strict out-of-band emission rules limit practical point-to-point power to lower levels.
- U-NII Mid : 5.250–5.350 GHz. Both outdoor and indoor use, subject to Dynamic Frequency Selection. Regulations allow for a user-installable antenna. Power limited to 250 mW.
- U-NII-2B: 5.350–5.470 GHz. Currently 120 MHz of spectrum not allocated by the FCC for unlicensed use.
- U-NII Worldwide : 5.470–5.725 GHz. Both outdoor and indoor use, subject to Dynamic Frequency Selection. Power limited to 250 mW. This spectrum was added by the FCC in 2003 to "align the frequency bands used by U-NII devices in the United States with bands in other parts of the world". The FCC currently has an interim limitation on operations on channels which overlap the 5600–5650 MHz band.
- U-NII Upper : 5.725–5.850 GHz. Sometimes referred to as U-NII / ISM due to overlap with the ISM band. Regulations allow for a user-installable antenna. Power limited to 1W
- DSRC/ITS : 5.850–5.925 GHz. At present U-NII-4 spectrum is being considered by the FCC for unlicensed use. U-NII-4 is presently only usable for Dedicated Short Range Communications Service and licensed amateur radio operators.
| Band | Freq. Range | Bandwidth | Max Power | Max EIRP |
| U-NII Low / U-NII-1 / U-NII Indoor | 5.150–5.250 GHz | 100 MHz | 50 mW | 200 mW |
| U-NII Mid / U-NII-2A | 5.250–5.350 GHz | 100 MHz | 250 mW | 1 W |
| U-NII-2B | 5.350–5.470 GHz | 120 MHz | — | — |
| U-NII Worldwide / U-NII-2C / U-NII-2-Extended / U-NII-2e | 5.470–5.725 GHz | 255 MHz | 250 mW | 1 W |
| U-NII Upper / U-NII-3 | 5.725-5.850 GHz | 125 MHz | 1 W | 200 W |
| DSRC/ITS / U-NII-4 | 5.850–5.925 GHz | 75 MHz | — | — |
| U-NII-5 | 5.925–6.425 GHz | 500 MHz | — | — |
| U-NII-6 | 6.425–6.525 GHz | 100 MHz | — | — |
| U-NII-7 | 6.525–6.875 GHz | 350 MHz | — | — |
| U-NII-8 | 6.875–7.125 GHz | 250 MHz | — | — |
Wireless ISPs generally use 5.725–5.825 GHz.
In the USA licensed amateur radio operators are authorized 5.650–5.925 GHz by Part 97.303 of the FCC rules.
U-NII is an FCC regulatory domain for 5 GHz wireless devices. U-NII power limits are defined by the United States CFR Title 47, Part 15 - Radio Frequency Devices, Subpart E - Unlicensed National Information Infrastructure Devices, Paragraph 15.407 - General technical requirements. Regulatory use in individual countries may differ.
The European HiperLAN standard operates in same frequency band as the U-NII.
5 GHz (802.11a">802.11a">a/h">802.11h">h/j">802.11j">j/n">802.11n">n)
Except where noted, all information taken from Annex J of IEEE 802.11-2007 modified by amendments k, y and n. Because countries set their own regulations regarding specific uses and maximum power levels within these frequency ranges, it is recommended that local authorities are consulted as regulations may change at any time.In 2007, the FCC began requiring that devices operating in channels 52, 56, 60 and 64 must have Dynamic Frequency Selection capabilities. This is to avoid communicating in the same frequency range as some radar. In 2014, the FCC issued new rules for all devices due to interference with government weather radar systems. Fines and equipment seizure were listed as punishment for non-compliance.