USC&GS George S. Blake
USC&GS George S. Blake, in service 1874–1905, is, with the U.S. Fish Commission steamer, one of only two US oceanographic vessels with her name inscribed in the façade of the Oceanographic Museum, Monaco due to her being "the most innovative oceanographic vessel of the Nineteenth Century" with development of deep ocean exploration through introduction of steel cable for sounding, dredging and deep anchoring and data collection for the "first truly modern bathymetric map of a deep sea area."
Construction
George S. Blake, a steam and sail schooner, was built at a cost of $84,600 in 1874 by E. J. Fardy, Baltimore, Maryland with dimensions of length with beam and draft of. It was named after late United States Naval Academy Superintendent George S. Blake.Notable events
Among the notable discoveries linked to the ship was the definition of bathymetry proving an unexpected at the time and unusual feature of the United States continental slope, now named for the ship as the Blake Plateau. Initial findings of such a plateau were found in June 1880 during investigations of the Gulf Stream. During her first survey season, starting in June 1874, George S. Blake was being used to test deep sea equipment designed by Sir William Thomson, the Thomson Sounding Machine, as modified by Commander Belknap, USN and to bring up specimens from in the Gulf of Maine. By the time the ship reached the Gulf of Mexico in 1875 under the command of Lieutenant Commander Charles Dwight Sigsbee, USN the ship was using a modification of the Thomson sounding machine designed by Sigsbee, known as the Sigsbee sounding machine that was the standard wire sounding device for fifty years, and with the shot release device first tested the previous year with Sigsbee attached to the survey party.The Gulf of Mexico
In addition to simple sounding, dredge samples, current measurements and even water column sampling with a "water cup devised" by Sigsbee, temperatures and other observations were made during surveys. By the close of the Gulf of Mexico surveys in 1876 the sounding lines and concurrent sampling by George S. Blake led to the assessment that "the data gathered this season may afford means for developing the main peculiarities of this large body of water"During 1876 the ship became involved in work undertaken to understand the Gulf Stream and John E. Pillsbury designed the Pillsbury current meter when he was George S. Blakes executive officer in 1876. Though other work was done in the stream, that meter was not used until Pillsbury took command of the ship in 1884. It was in association with that work that the deep soundings across the current would reveal the Blake Plateau.
By 1878 the Gulf Stream and Gulf work would see the addition of Alexander Agassiz, who joined the ship in December 1877 in Havana, with dredges and trawls for deep biological sampling. By June 1879 the ship had been completely refitted for deep sea sounding and dredging work. Under the command of John Pillsbury, from 1884 to 1889, the ship intensified Gulf Stream work with current measurements using his device, sounding lines from shore to beyond the current, temperatures and biological sampling.
Atlantic-Caribbean passages
In November 1878, Lieutenant Commander Sigsbee had completed deep surveys of the Gulf of Mexico and turned over command to Commander John R. Bartlett, USN Bartlett exploited Sigsbee's development of the Sigsbee sounding machine and George S. Blakes refit to survey with Professor Agassiz in company for biological sample dredging, in the Windward Passage and the Caribbean. Agassiz left the ship at Barbados, reached March 1879 with malaria aboard, the dredging equipment unrigged and sounding lines run in the passages of the Windward Islands where it was noted "the channels thus developed seem to be merely depressions in a range of partly submerged mountains" while current measurements began to reveal actual circulation patterns in that part of the Atlantic.In his own report Agassiz noted "One of the most interesting results reached by this year's cruise is the light thrown upon the former extension of the South American continent by the soundings taken while dredging, and those subsequently made in the passages between the islands by Commander Bartlett. Those together with soundings already known, enable us to trace the outline of the old continent... and thus obtain some intelligible, and at the same time trustworthy, explanation of the peculiar geographical distribution of the fauna and flora of the West India Islands."
The Gulf Stream and Blake Plateau
By 1880 George S. Blake current data was supporting Bartlett's theory that "much of the supply for the Gulf Stream passes near the eastern end of Cuba." With Gulf Stream work coming to the fore the next season, a new electrical apparatus for recording temperatures was installed. After a northern season with Agassiz again aboard for dredging on Georges Bank, the ship went into winter lay up before setting out from Providence, Rhode Island 4 May 1881 for work in the Gulf Stream, described as:With Agassiz collecting biological samples and examining the Gulf Stream running from Cape Romain eastward, taking frequent soundings, Bartlett noted "depths on this line were unexpectedly small, the axis of the Gulf Stream being crossed before a depth of three hundred fathoms was found", with a bottom of "hard coral" and little life. This was early indication of the plateau that would in the future carry the ship's name, and by 1882 Commander Bartlett had described the plateau in considerable detail:
Bartlett reported the scouring effect of the current on the plateau, noting that on each side of the current the sounding cylinder, a device for sampling the nature of the bottom with the sounding, brought up ooze. In the current the "bottom was washed nearly bare" with particles being small and broken pieces of coral rock and so hard the sharp edge of the brass cylinder was bent.
In summary, the National Oceanic and Atmospheric Administration's History of NOAA Ocean Exploration: Breakthrough Years notes:
Service history
Under the command of Commander John A. Howell, USN, George S. Blake immediately began innovative deep ocean work in 1874. Attached to the ship in the Gulf of Mexico was Lieutenant Commander D. Sigsbee to test his new device for releasing the heavy shot weights used in deep soundings. With development and installation of Sigsbee's sounding machine George S. Blake became the primary deep ocean sounding ship alternating between the Gulf of Maine and northern waters in summer and southern waters in winter. Soundings in the Gulf of Mexico by the end of 1875 were sufficient for production of the first true oceanic basin bathymetric chart.By 1883 George S. Blakes boiler had "exceeded the limit of profitable repairs" and a contract was let for replacing the single boiler with two new designs in December 1883 with William L. Pettit, Baltimore. To fit within the old space the new boilers were of elliptical design. Delays in boiler completion were used to realign the shaft and for bottom repair.
George S. Blake worked in the vicinity of Nantucket and Boston until 21 September 1892. She was in New York on 11 and 12 October to take part in the New York Columbian Celebration before heading south to make an examination of part of the Hatteras Shoal. On her return north she picked up the Survey's schooner for tow on 2 December 1892 in Norfolk from where both ships went to the Washington Navy Yard. George S. Blake prepared there for her appearance at the World's Columbian Exposition in Chicago there until 2 April 1893 when she sailed north to join Bache in a special mission. The commanding officers of both Bache and George S. Blake had been directed on 30 March 1893, to support the speed trials of the new cruiser, in Newport Harbor. The final trial was over a course laid out in 1890 by the Coast and Geodetic Survey. The vessels supported current measurements on the course using the Pillsbury current meter through 17 April. George S. Blake then proceeded to Chicago, Illinois, to be a part of the Coast Survey's exhibit at the World's Columbian Exposition where she remained until 5 October 1893, sailing from Chicago 15 October and arriving in Baltimore on 24 November 1893.
Congress had instituted a radical change in the crewing of the vessels through appropriation law approved 6 June 1900 to the effect that beginning 1 July 1900 "all necessary employees to man and equip the vessels" were funded as opposed to the previous scheme in which US Navy officers had commanded and navy enlisted personnel had crewed the Survey's vessels. By prearrangement all naval personnel would remain with the ships until the first call at the home port, where the transfer would be made with the Survey reimbursing the navy for pay after 1 July for those personnel.