Vestas V90-3MW


The Vestas V90-3MW is a three-bladed upwind wind turbine generator that uses pitch control and a doubly fed induction generator. Its manufacturer claims to have installed over 500 units of this type globally since launch.
Vestas claims the turbine provides 50% more power for roughly the same weight as the V80. The V90-3MW should not be confused with the V90-2MW, which is essentially a V80-2MW with longer blades. It is produced in both an on and offshore version.
The first V90-3MW was erected in northern Germany in May 2002. 15 test turbines were deployed around the world in different climatic conditions, so that when it went into production, the V90-3MW had been tested in more sites than the V80-2MW. Following a number of gearbox problems, the V90-3MW was withdrawn for offshore sales in early 2007 before being reissued for offshore use in May 2008. Presently, the nacelles are exclusively made at the Vestas Nacelles works in Taranto, Italy. Towers and blades may come from a number of locations. Vestas produces a 3.65 MW low-wind version called the V136.

Technical details

ParameterValue
Rated Power3000 kW
ConceptVariable speed, DFIG generator with pitch control
Nacelle weight70 t
Rotor diameter
Rotor weight41 t
Speed controlIndependent pitch control to each blade
GeneratorWater cooled, various suppliers
GearboxHansen, two planetary and one helical, 1:100 step up
Cut In4 m/s
Rated15 m/s
Cut Out25 m/s

Towers may weigh 160 t if 80 m tall, or 285 t at 105 m.

Differences between V90-3 and V90-2/V80s

Differences from its predecessor model the V80 include use of an oil cooled generator, and a compact gearbox, which now butts up directly to the hub rather than through a low speed shaft. The V90-3MW can be differentiated from the V80 by the shape of the nacelle, which has a cut-out profile at the back. Other differences include:
The V90-3MW can be specified with one of five different 'noise modes'. Each mode is set in the turbine software as part of the installation, although may be changed to another mode later. Each different noise mode implies a different power curve, so that for quieter operation, some energy yield is sacrificed. Noise mitigation is managed by adjustments to the blade pitch angle.
For licensing reasons, the 60 Hz model sold in the US and Canada uses a slightly different converter system, allowing only one-way power flow through the rotor converter, rather than 2-way power flow used in the standard version. This restriction does not apply to 60 Hz models sold in other regions.

Offshore use

The V90-3MW is used offshore in the following wind farms: