Wide Area Augmentation System


The Wide Area Augmentation System is an air navigation aid developed by the Federal Aviation Administration to augment the Global Positioning System, with the goal of improving its accuracy, integrity, and availability. Essentially, WAAS is intended to enable aircraft to rely on GPS for all phases of flight, including precision approaches to any airport within its coverage area. It may be further enhanced with the Local Area Augmentation System also known by the preferred ICAO term Ground-Based Augmentation System in critical areas.
WAAS uses a network of ground-based reference stations, in North America and Hawaii, to measure small variations in the GPS satellites' signals in the western hemisphere. Measurements from the reference stations are routed to master stations, which queue the received Deviation Correction and send the correction messages to geostationary WAAS satellites in a timely manner. Those satellites broadcast the correction messages back to Earth, where WAAS-enabled GPS receivers use the corrections while computing their positions to improve accuracy.
The International Civil Aviation Organization calls this type of system a satellite-based augmentation system. Europe and Asia are developing their own SBASs, the Indian GPS Aided Geo Augmented Navigation, the European Geostationary Navigation Overlay Service and the Japanese Multi-functional Satellite Augmentation System, respectively. Commercial systems include StarFire, OmniSTAR, and Atlas.

WAAS objectives

Accuracy

The WAAS specification requires it to provide a position accuracy of or less, at least 95% of the time. Actual performance measurements of the system at specific locations have shown it typically provides better than laterally and vertically throughout most of the contiguous United States and large parts of Canada and Alaska. With these results, WAAS is capable of achieving the required Category I precision approach accuracy of laterally and vertically.

Integrity

Integrity of a navigation system includes the ability to provide timely warnings when its signal is providing misleading data that could potentially create hazards. The WAAS specification requires the system detect errors in the GPS or WAAS network and notify users within 6.2 seconds. Certifying that WAAS is safe for instrument flight rules requires proving there is only an extremely small probability that an error exceeding the requirements for accuracy will go undetected. Specifically, the probability is stated as 1×10−7, and is equivalent to no more than 3 seconds of bad data per year. This provides integrity information equivalent to or better than Receiver Autonomous Integrity Monitoring.

Availability

Availability is the probability that a navigation system meets the accuracy and integrity requirements. Before the advent of WAAS, GPS specifications allowed for system unavailability for as much as a total time of four days per year. The WAAS specification mandates availability as 99.999% throughout the service area, equivalent to a downtime of just over 5 minutes per year.

Operation

WAAS is composed of three main segments: the ground segment, space segment, and user segment.

Ground segment

The ground segment is composed of multiple Wide-area Reference Stations. These precisely surveyed ground stations monitor and collect information on the GPS signals, then send their data to three Wide-area Master Stations using a terrestrial communications network. The reference stations also monitor signals from WAAS geostationary satellites, providing integrity information regarding them as well. As of October 2007 there were 38 WRSs: twenty in the contiguous United States, seven in Alaska, one in Hawaii, one in Puerto Rico, five in Mexico, and four in Canada.
Using the data from the WRS sites, the WMSs generate two different sets of corrections: fast and slow. The fast corrections are for errors which are changing rapidly and primarily concern the GPS satellites' instantaneous positions and clock errors. These corrections are considered user position-independent, which means they can be applied instantly by any receiver inside the WAAS broadcast footprint. The slow corrections include long-term ephemeric and clock error estimates, as well as ionospheric delay information. WAAS supplies delay corrections for a number of points across the WAAS service area .
Once these correction messages are generated, the WMSs send them to two pairs of Ground Uplink Stations, which then transmit to satellites in the Space segment for rebroadcast to the User segment.

Space segment

The space segment consists of multiple communication satellites which broadcast the correction messages generated by the WAAS Master Stations for reception by the user segment. The satellites also broadcast the same type of range information as normal GPS satellites, effectively increasing the number of satellites available for a position fix. The space segment currently consists of three commercial satellites: Eutelsat 117 West B, Telesat's Anik F1R, and SES-15. A fourth satellite, Galaxy 30, is set for launch in 2020.
Satellite History
The original two WAAS satellites, named Pacific Ocean Region and Atlantic Ocean Region-West, were leased space on Inmarsat III satellites. These satellites ceased WAAS transmissions on July 31, 2007. With the end of the Inmarsat lease approaching, two new satellites were launched in late 2005. is a PanAmSat, and Anik F1R is a Telesat. As with the previous satellites, these are leased services under the FAA's Geostationary Satellite Communications Control Segment contract with Lockheed Martin for WAAS geostationary satellite leased services, who were contracted to provide up to three satellites through the year 2016.
A third satellite was later added to the system. From March to November 2010, the FAA broadcast a WAAS test signal on a leased transponder on the Inmarsat-4 F3 satellite. The test signal was not usable for navigation, but could be received and was reported with the identification numbers PRN 133. In November 2010, the signal was certified as operational and made available for navigation. Following in orbit testing, Eutelsat 117 West B, broadcasting signal on PRN 131, was certified as operational and made available for navigation on March 27, 2018. The SES 15 satellite was launched on May 18, 2017 and following an in-orbit test of several months, was set operational on July 15, 2019. In 2018, a contract was awarded to place a WAAS L-band payload on the Galaxy 30 satellite, slated to be launched in 2020. The satellite will re-use PRN 135.
Satellite name and detailsPRNNMEALocation
Eutelsat 117 West B13144117°W
Inmarsat-4 F3
Ceased WAAS transmissions as of Nov 9, 2017
1334698°W
SES 15
Operational
13346129°W
Galaxy 15
Ceased WAAS transmissions on July 25, 2019.
13548133°W

Set to launch in 2020
13548125°W
Anik F1R
Planned decommission in 2020.
13851107.3°W

Ceased WAAS transmissions on July 31, 2017
13447178°E

Ceased WAAS transmissions on July 31, 2017
1223554°W, later moved to 142°W

In the table above, PRN is the satellite's actual Pseudo-Random Noise code. NMEA is the satellite number sent by some receivers when outputting satellite information..

User segment

The user segment is the GPS and WAAS receiver, which uses the information broadcast from each GPS satellite to determine its location and the current time, and receives the WAAS corrections from the Space segment. The two types of correction messages received are used in different ways.
The GPS receiver can immediately apply the fast type of correction data, which includes the corrected satellite position and clock data, and determines its current location using normal GPS calculations. Once an approximate position fix is obtained the receiver begins to use the slow corrections to improve its accuracy. Among the slow correction data is the ionospheric delay. As the GPS signal travels from the satellite to the receiver, it passes through the ionosphere. The receiver calculates the location where the signal pierced the ionosphere and, if it has received an ionospheric delay value for that location, corrects for the error the ionosphere created.
While the slow data can be updated every minute if necessary, ephemeris errors and ionosphere errors do not change this frequently, so they are only updated every two minutes and are considered valid for up to six minutes.

History and development

The WAAS was jointly developed by the United States Department of Transportation and the Federal Aviation Administration as part of the , beginning in 1994, to provide performance comparable to category 1 instrument landing system for all aircraft possessing the appropriately certified equipment. Without WAAS, ionospheric disturbances, clock drift, and satellite orbit errors create too much error and uncertainty in the GPS signal to meet the requirements for a precision approach. A precision approach includes altitude information and provides course guidance, distance from the runway, and elevation information at all points along the approach, usually down to lower altitudes and weather minimums than non-precision approaches.
Prior to the WAAS, the U.S. National Airspace System did not have the ability to provide lateral and vertical navigation for precision approaches for all users at all locations. The traditional system for precision approaches is the instrument landing system, which used a series of radio transmitters each broadcasting a single signal to the aircraft. This complex series of radios needs to be installed at every runway end, some offsite, along a line extended from the runway centerline, making the implementation of a precision approach both difficult and very expensive. The ILS system is composed of 180 different transmitting antennas at each point built. The newer system is free of huge antenna systems at each airport.
For some time the FAA and NASA developed a much improved system, the microwave landing system. The entire MLS system for a particular approach was isolated in one or two boxes located beside the runway, dramatically reducing the cost of implementation. MLS also offered a number of practical advantages that eased traffic considerations, both for aircraft and radio channels. Unfortunately, MLS would also require every airport and aircraft to upgrade their equipment.
During the development of MLS, consumer GPS receivers of various quality started appearing. GPS offered a huge number of advantages to the pilot, combining all of an aircraft's long-distance navigation systems into a single easy-to-use system, often small enough to be hand held. Deploying an aircraft navigation system based on GPS was largely a problem of developing new techniques and standards, as opposed to new equipment. The FAA started planning to shut down their existing long-distance systems in favor of GPS. This left the problem of approaches, however. GPS is simply not accurate enough to replace ILS systems. Typical accuracy is about, whereas even a "CAT I" approach, the least demanding, requires a vertical accuracy of.
This inaccuracy in GPS is mostly due to large "billows" in the ionosphere, which slow the radio signal from the satellites by a random amount. Since GPS relies on timing the signals to measure distances, this slowing of the signal makes the satellite appear farther away. The billows move slowly, and can be characterized using a variety of methods from the ground, or by examining the GPS signals themselves. By broadcasting this information to GPS receivers every minute or so, this source of error can be significantly reduced.
This led to the concept of Differential GPS, which used separate radio systems to broadcast the correction signal to receivers. Aircraft could then install a receiver which would be plugged into the GPS unit, the signal being broadcast on a variety of frequencies for different users. Broadcasters of the required power generally cluster around larger cities, making such DGPS systems less useful for wide-area navigation. Additionally, most radio signals are either line-of-sight, or can be distorted by the ground, which made DGPS difficult to use as a precision approach system or when flying low for other reasons.
The FAA considered systems that could allow the same correction signals to be broadcast over a much wider area, such as from a satellite, leading directly to WAAS. Since a GPS unit already consists of a satellite receiver, it made much more sense to send out the correction signals on the same frequencies used by GPS units, than to use an entirely separate system and thereby double the probability of failure. In addition to lowering implementation costs by "piggybacking" on a planned satellite launch, this also allowed the signal to be broadcast from geostationary orbit, which meant a small number of satellites could cover all of North America.
On July 10, 2003, the WAAS signal was activated for general aviation, covering 95% of the United States, and portions of Alaska offering minimums.
On January 17, 2008, Alabama-based Hickok & Associates became the first designer of helicopter WAAS with Localizer Performance and Localizer Performance with Vertical guidance approaches, and the only entity with FAA-approved criteria. This helicopter WAAS criteria offers as low as 250 foot minimums and decreased visibility requirements to enable missions previously not possible. On April 1, 2009, FAA AFS-400 approved the first three helicopter WAAS GPS approach procedures for Hickok & Associates' customer California Shock/Trauma Air Rescue. Since then they have designed many approved WAAS helicopter approaches for various EMS hospitals and air providers, within the United States as well as in other countries and continents.
On December 30, 2009, Seattle-based Horizon Air flew the first scheduled-passenger service flight using WAAS with LPV on flight 2014, a Portland to Seattle flight operated by a Bombardier Q400 with a WAAS FMS from . The airline, in partnership with the FAA, will outfit seven Q400-aircraft with WAAS and share flight data to better determine the suitability of WAAS in scheduled air service applications.

Timeline

Comparison of accuracy

Benefits

WAAS addresses all of the "navigation problem", providing highly accurate positioning that is extremely easy to use, for the cost of a single receiver installed on the aircraft. Ground- and space-based infrastructure is relatively limited, and no on-airport system is needed. WAAS allows a precision approach to be published for any airport, for the cost of developing the procedures and publishing the new approach plates. This means that almost any airport can have a precision approach and the cost of implementation is dramatically reduced.
Additionally WAAS works just as well between airports. This allows the aircraft to fly directly from one airport to another, as opposed to following routes based on ground-based signals. This can cut route distances considerably in some cases, saving both time and fuel. In addition, because of its ability to provide information on the accuracy of each GPS satellite's information, aircraft equipped with WAAS are permitted to fly at lower en-route altitudes than was possible with ground-based systems, which were often blocked by terrain of varying elevation. This enables pilots to safely fly at lower altitudes, not having to rely on ground-based systems. For unpressurized aircraft, this conserves oxygen and enhances safety.
The above benefits create not only convenience, but also have the potential to generate significant cost savings. The cost to provide the WAAS signal, serving all 5,400 public use airports, is just under US$50 million per year. In comparison, the current ground based systems such as the Instrument Landing System, installed at only 600 airports, cost US$82 million in annual maintenance. Without ground navigation hardware to purchase, the total cost of publishing a runway's WAAS approach is approximately US$50,000; compared to the $1,000,000 to $1,500,000 cost to install an ILS radio system.
Further savings can come from the nighttime closure of airport towers with a low volume of traffic. The FAA is reviewing 48 towers for such a potential reduction of services, which it estimates will save around US$100,000 per year at each tower, for a total annual savings of nearly US$5 million.

Drawbacks and limitations

For all its benefits, WAAS is not without drawbacks and critical limitations:

Improvement to aviation operations

In 2007, WAAS vertical guidance was projected to be available nearly all the time, and its coverage encompasses the full continental U.S., most of Alaska, northern Mexico, and southern Canada. At that time, the accuracy of WAAS would meet or exceed the requirements for Category 1 ILS approaches, namely, three-dimensional position information down to 200 feet above touchdown zone elevation.

Software improvements

Software improvements, to be implemented by September 2008, significantly improve signal availability of vertical guidance throughout the CONUS and Alaska. Area covered by the 95% available LPV solution in Alaska improves from 62% to 86%. And in the CONUS, the 100% availability LPV-200 coverage rises from 48% to 84%, with 100% coverage of the LPV solution.

Space segment upgrades

Both Galaxy XV and Anik F1R contain an L1 & L5 GPS payload. This means they will potentially be usable with the L5 modernized GPS signals when the new signals and receivers become available. With L5, avionics will be able to use a combination of signals to provide the most accurate service possible, thereby increasing availability of the service. These avionics systems will use ionospheric corrections broadcast by WAAS, or self-generated onboard dual frequency corrections, depending on which one is more accurate.