XM148 grenade launcher


The XM148 was an experimental 40 mm grenade launcher developed by Colt Firearms as the CGL-4. Colt manufactured the launcher for field testing during the Vietnam era. After problems with the experimental design were discovered, the XM148 was replaced by AAI Corporation's conceptually similar M203 design, currently the primary grenade launcher used by the US armed forces and others today.

Description

The Colt XM148 grenade launcher was created by Colt's Design Project Engineer, gun designer . The May 1967 "Colt's Ink" newsletter announced that he had won a national competition for his selection and treatment of materials in the design. The stated in part, "In only 47 days, he wrote the specifications, designed the launcher, drew all the original prints, and had a working model built."
The weapon was designed for installation below the barrel of M16-type rifles, and was intended to replace the stand-alone M79 correcting the problem of grenadiers relying on pistols as a secondary weapon.
In July 1966 the US Government contracted Colt Firearms to provide nearly 20,000 XM-148s with the weapon arriving in South Vietnam in December 1966. The weapon was pulled from service in the fall of 1967.
Originally made for use with the M16 Rifle, the XM148 was used by US Special Forces in conjunction with the XM177E2 and the Australian Special Air Service Regiment in conjunction with the modified L1A1 and Sterling Submachine Gun. The weapon was also adopted by the United States Air Force Security Forces in 1968.

Problems

The launcher's barrel could slide forward to accept a single 40 mm round into the breech. It came with a primitive version of the quadrant sight later used with the M203. It differed from the later model by featuring an external cocking handle and an extended trigger that allowed the weapon to be fired without removing the hand from the rifle's pistol grip. This same extended trigger was also one source of the weapon's problems as it allowed accidental discharges of a loaded weapon if caught by tree branches, gear, or anything else capable of overcoming the 6 to 11 pound trigger pull.
Another problem with the weapon was that it was overcomplicated compared to the M203. It was difficult to disassemble and had many small parts that could be easily lost while cleaning the weapon in the field. Where the M203 broke down into receiver group, barrel group, hand guard group and quadrant sight, the XM148 broke down into barrel, pistol grip, receiver, hand guard, quadrant sight, and several small pins and clips. These issues led the U.S. military to adopt the M203 over the XM148, though the U.S. Air Force did keep a number of the XM148s. In fact U.S. Air Force Security Forces were still being trained on the XM148 in lieu of the M203 as late as 1989. Some security police units still had them in their armories until the 1990s.