The Yakovlev Yak-36, also known as Izdeliye V, is a Soviet technology demonstrator for a VTOL combat aircraft.
Design and development
From 1960, the Yakovlev Design Bureau began work on a VTOL system, using the compact and lightweight Tumansky RU-19-300turbojet engine, drafting a proposal for the Yak-104, a converted Yak-30 jet trainer with two vertically mounted Ru-19 engines between the inlet ducts of the standard Yak-30 powerplant. Work on the Yak-104 was terminated in favour of an aircraft with a single lift/cruise engine with rotating nozzles, similar to the Hawker Siddeley P.1127, which was nearing completion in England. Unable to find a suitable engine or convince the government to order the development of one, the Yakovlev bureau was forced to follow a different course. In response to a contract for the development of a single-seat V/STOL fighter in 1961, Yakovlev proposed a twin-engined aircraft with a large nose air intake, engines in the forward fuselage and swivelling exhaust nozzles, one for each engine on either side of the lower fuselage near the centre of gravity of the aircraft. The fighter version was not proceeded with but four technology demonstrators, based on the fighter studies were ordered. Four prototypes were completed, one of which was used only for static testing. The second was used for takeoff and landing tests, including free hovering. The third incorporated improvements found in testing, including an improved autopilot which automatically selected optimal air flow for hover stability. This prototype crashed, but was later rebuilt. The fourth prototype crashed in February 1971 and was not rebuilt.
Construction
The airframe had a semi-monocoque fuselage with bicycle-type landing gear, short cropped delta wings of 37° leading edge sweep, with 5° anhedral, attached to the fuselage in a mid position. The fuselage was substantial forward of the wing trailing edges, due to accommodating the engines, cockpit, fuel tanks and equipment bays as close to the centre of gravity as possible, tapering sharply to the swept tail surfaces with a high-set tailplane. Control of the aircraft was by conventional rudder, ailerons and elevators in normal flight and by compressed engine bleed air blown from control nozzles at the wingtips, rear fuselage tip and at the end of a long boom extending forwards from the top lip of the air intakes. Two underwing hard points could carry bombs, podded machine guns or rocket pods, but the Yak-36 had insufficient excess thrust and range for effective use as a combat aircraft.
Operational history
The first tethered hover flight took place on 9 January 1963. There were initial problems with hot gas reingestion where hot exhaust gasses are sucked back into the intakes causing poor airflow through the engines and loss of thrust. The suction effect of the exhaust on the ground and problems with control systems caused further difficulties. After modifications, the first untethered vertical flight was made on 23 June 1963, followed by the first full transition to horizontal flight on 16 September 1963. On 24 March 1966, the first complete flight was made from vertical takeoff transition to horizontal flight deceleration to vertical flight and vertical landing. After much testing and practice the first public presentation of the Yak-36 was made on 9 July 1967 at an air show at Moscow-Domodedovo airport, marking the 50th Anniversary of the October Revolution. After the promising results obtained from the flight test programme of the Yak-36, the next development step was the Yakovlev Yak-36M which flew for the first time on 27 September 1970.
