Since the invention of the floppy disk drive, various standardized form factors have been used in computing systems. Standardized form factors and interface allow a variety of peripherals and upgrades thereto with no impact to the physical size of a computer system. Drives may slot into a drive bay of the corresponding size.
Form factors
IBM's first hard drive, the IBM 350, used a stack of fifty 24-inch platters and was of a size comparable to two large refrigerators. In 1962, IBM introduced its model 1311 disk, which used six 14-inch platters in a removable pack and was roughly the size of a washing machine. This became a standard platter size and drive form-factor for many years, used also by other manufacturers. The IBM 2314 used platters of the same size in an eleven-high pack and introduced the "drive in a drawer" layout, although the "drawer" was not the complete drive. Later drives were designed to fit entirely into a chassis that would mount in a 19-inch rack. Digital's RK05 and RL01 were early examples using single 14-inch platters in removable packs, the entire drive fitting in a 10.5-inch-high rack space. In the mid-to-late 1980s the similarly sizedFujitsu Eagle, which used 10.5-inch platters, was a popular product. Such large platters were never used with microprocessor-based systems. With increasing sales of microcomputers having built in floppy-disk drives, HDDs that would fit to the FDD mountings became desirable. Thus HDD Form factors, initially followed those of 8-inch, 5.25-inch, and 3.5-inch floppy disk drives. Because there were no smaller floppy disk drives, smaller HDD form factors developed from product offerings or industry standards. ; 8-inch ; 5.25-inch ; 3.5-inch ; 2.5-inch ; 1.8-inch ; 1-inch ; 0.85-inch , 2.5-inch and 3.5-inch hard disks were the most popular sizes. By 2009, all manufacturers had discontinued the development of new products for the 1.3-inch, 1-inch and 0.85-inch form factors due to falling prices of flash memory, which has no moving parts. While these sizes are customarily described by an approximately correct figure in inches, actual sizes have long been specified in millimeters. The older 3.5-inch form factor uses UNC threads, while 2.5-inch drives use metric M3 threads.
