The famous Michelson–Morley experiment of 1887 showed that the then-accepted aether theory needed to be modified. FitzGerald and Lorentz, independently of each other, proposed a length contraction of the experimental apparatus in the direction of motion that would explain the almost null result of the Michelson–Morley experiment. The first attempts to measure some consequences of this contraction in the lab frame were made in the experiments of Rayleigh and Brace, though the result was negative. By 1908, however, the then-current theories of electrodynamics, Lorentz ether theory and special relativity, predicted that the Lorentz–FitzGerald contraction is not measurable in a co-moving frame, because these theories were based on the Lorentz transformation. as the circuit is rotated. Frederick Thomas Trouton,, instead did the calculations using his own interpretation of electrodynamics, calculating the length contraction according to the velocity of the experimental apparatus in the aether frame, but calculating the electrodynamics by applying Maxwell's equations and Ohm's law in the lab frame. According to Trouton's view of electrodynamics, the calculations then predicted a measurable effect of the length contraction in the lab frame. Together with Alexander Oliver Rankine, he set out to verify this in 1908 by attempting to measure the change of the resistance of a coil as they changed its orientation to the "aether velocity". This was done by putting four identical such coils in a Wheatstone bridge configuration which allowed them to precisely measure any change in resistance. The circuit was then rotated through 90 degrees about its axis as the resistance was measured. Because the Lorentz–FitzGerald contraction is only in the direction of motion, from the point of view of the "Aether frame" the length of the coils depended on their angle with respect to their Aether velocity. Trouton and Rankine therefore believed that the resistance as measured in the rest frame of the experiment should change as the device was rotated. However their careful measurements showed no detectable change in resistance. This showed that if the Lorentz–FitzGerald contraction existed, it was not measurable in the rest frame of the object – only theories containing the complete Lorentz transformation, like special relativity, are still valid.