Tests of relativistic energy and momentum
Tests of relativistic energy and momentum are aimed at measuring the relativistic expressions for energy, momentum, and mass. According to special relativity, the properties of particles moving approximately at the speed of light significantly deviate from the predictions of Newtonian mechanics. For instance, the speed of light cannot be reached by massive particles.
Today, those relativistic expressions for particles close to the speed of light are routinely confirmed in undergraduate laboratories, and necessary in the design and theoretical evaluation of collision experiments in particle accelerators. See also Tests of special relativity for a general overview.
Overview
In classical mechanics, kinetic energy and momentum are expressed asOn the other hand, special relativity predicts that the speed of light is constant in all inertial frames of references. The relativistic energy–momentum relation reads:
from which the relations for rest energy, relativistic energy , kinetic energy, and momentum of massive particles follow:
where. So relativistic energy and momentum significantly increase with speed, thus the speed of light cannot be reached by massive particles. In some relativity textbooks, the so-called "relativistic mass" is used as well. However, this concept is considered disadvantageous by many authors, instead the expressions of relativistic energy and momentum should be used to express the velocity dependence in relativity, which provide the same experimental predictions.
Early experiments
First experiments capable of detecting such relations were conducted by Walter Kaufmann, Alfred Bucherer and others between 1901 and 1915. These experiments were aimed at measuring the deflection of beta rays within a magnetic field so as to determine the mass-to-charge ratio of electrons. Since the charge was known to be velocity independent, any variation had to be attributed to alterations in the electron's momentum or mass. Since relativistic mass is not often used anymore in modern textbooks, those tests can be described of measurements of relativistic momentum or energy, because the following relation applies:Electrons traveling between 0.25–0.75c indicated an increase of momentum in agreement with the relativistic predictions, and were considered as clear confirmations of special relativity. However, it was later pointed out that although the experiments were in agreement with relativity, the precision wasn't sufficient to rule out competing models of the electron, such as the one of Max Abraham.
Already in 1915, however, Arnold Sommerfeld was able to derive the Fine structure of hydrogen-like spectra by using the relativistic expressions for momentum and energy. Subsequently, Karl Glitscher simply replaced the relativistic expression's by Abraham's, demonstrating that Abraham's theory is in conflict with experimental data and is therefore refuted, while relativity is in agreement with the data.
Precision measurements
In 1940, Rogers et al. performed the first electron deflection test sufficiently precise to definitely rule out competing models. As in the Bucherer-Neumann experiments, the velocity and the charge-mass-ratio of beta particles of velocities up to 0.75c was measured. However, they made many improvements, including the employment of a Geiger counter. The accuracy of the experiment by which relativity was confirmed was within 1%.An even more precise electron deflection test was conducted by Meyer et al.. They tested electrons traveling at velocities from 0.987 to 0.99c, which were deflected in a static homogenous magnetic field by which p was measured, and a static cylindrical electric field by which was measured. They confirmed relativity with an upper limit for deviations of ∼0.00037.
Also measurements of the charge-to-mass ratio and thus momentum of protons have been conducted. Grove and Fox measured 385-MeV protons moving at ∼0.7c. Determination of the angular frequencies and of the magnetic field provided the charge-to-mass ratio. This, together with measuring the magnetic center, allowed to confirm the relativistic expression for the charge-to-mass ratio with a precision of ∼0.0006.
However, Zrelov et al. criticized the scant information given by Grove and Fox, emphasizing the difficulty of such measurements due to the complex motion of the protons. Therefore, they conducted a more extensive measurement, in which protons of 660 MeV with mean velocity of 0.8112c were employed. The proton's momentum was measured using a Litz wire, and the velocity was determined by evaluation of Cherenkov radiation. They confirmed relativity with an upper limit for deviations of ∼0.0041.
Bertozzi experiment
Since the 1930s, relativity was needed in the construction of particle accelerators, and the precision measurements mentioned above clearly confirmed the theory as well. But those tests demonstrate the relativistic expressions in an indirect way, since many other effects have to be considered in order to evaluate the deflection curve, velocity, and momentum. So an experiment specifically aimed at demonstrating the relativistic effects in a very direct way was conducted by William Bertozzi.He employed the electron accelerator facility at MIT in order to initiate five electron runs, with electrons of kinetic energies between 0.5 and 15 MeV. These electrons were produced by a Van de Graaff generator and traveled a distance of 8.4 m, until they hit an aluminium disc. First, the time of flight of the electrons was measured in all five runs – the velocity data obtained were in close agreement with the relativistic expectation. However, at this stage the kinetic energy was only indirectly determined by the accelerating fields. Therefore, the heat produced by some electrons hitting the aluminium disc was measured by calorimetry in order to directly obtain their kinetic energy - those results agreed with the expected energy within 10% error margin.
Undergraduate experiments
Various experiments have been performed which, due to their simplicity, are still used as undergraduate experiments. Mass, velocity, momentum, and energy of electrons have been measured in different ways in those experiments, all of them confirming relativity. They include experiments involving beta particles, Compton scattering in which electrons exhibit highly relativistic properties and positron annihilation.Particle accelerators
In modern particle accelerators at high energies, the predictions of special relativity are routinely confirmed, and are necessary for the design and theoretical evaluation of collision experiments, especially in the ultrarelativistic limit.For instance, time dilation must be taken into account to understand the dynamics of particle decay, and the relativistic velocity addition theorem explains the distribution of synchrotron radiation. Regarding the relativistic energy-momentum relations, a series of high precision velocity and energy-momentum experiments have been conducted, in which the energies employed were necessarily much higher than the experiments mentioned above.
Velocity
measurements have been conducted to measure differences in the velocities of electrons and light at the SLAC National Accelerator Laboratory. For instance, Brown et al. found no difference in the time of flight of 11-GeV electrons and visible light, setting an upper limit of velocity differences of.Another SLAC experiment conducted by Guiragossián et al. accelerated electrons up to energies of 15 to 20.5 GeV. They used a radio frequency separator to measure time-of-flight differences and thus velocity differences between those electrons and 15-GeV gamma rays on a path length of 1015 m. They found no difference, increasing the upper limit to.
Already before, Alväger et al. at the CERN Proton Synchrotron executed a time of flight measurement to test the Newtonian momentum relations for light, being valid in the so-called emission theory. In this experiment, gamma rays were produced in the decay of 6-GeV pions traveling at 0.99975c. If Newtonian momentum were valid, those gamma rays should have traveled at superluminal speeds. However, they found no difference and gave an upper limit of.
Energy and Calorimetry
The intrusion of particles into particle detectors is connected with electron–positron annihilation, Compton scattering, Cherenkov radiation etc., so that a cascade of effects is leading to the production of new particles. The energy of such particle showers corresponds to the relativistic kinetic energy and rest energy of the initial particles. This energy can be measured by calorimeters in an electrical, optical, thermal, or acoustical way.Thermal measurements in order to estimate the relativistic kinetic energy were already carried out by Bertozzi as mentioned above. Additional measurements at SLAC followed, in which the heat produced by 20-GeV electrons was measured in 1982. A beam dump of water-cooled aluminium was employed as calorimeter. The results were in agreement with special relativity, even though the accuracy was only 30%.
However, the experimentalists alluded to the fact, that calorimetric tests with 10-GeV electrons were executed already in 1969. There, copper was used as beam dump, and an accuracy of 1% was achieved.
In modern calorimeters called electromagnetic or hadronic depending on the interaction, the energy of the particle showers is often measured by the ionization caused by them. Also excitations can arise in scintillators, whereby light is emitted and then measured by a scintillation counter. Cherenkov radiation is measured as well. In all of those methods, the measured energy is proportional to the initial particle energy.
Annihilation and pair production
Relativistic energy and momentum can also be measured by studying processes such as annihilation and pair production. For instance, the rest energy of electrons and positrons is 0.51 MeV respectively. When a photon interacts with an atomic nucleus, electron-positron pairs can be generated in case the energy of the photon matches the required threshold energy, which is the combined electron-positron rest energy of 1.02 MeV. However, if the photon energy is even higher, than the exceeding energy is converted into kinetic energy of the particles. The reverse process occurs in electron-positron annihilation at low energies, in which process photons are created having the same energy as the electron-positron pair. These are direct examples of .There are also many examples of conversion of relativistic kinetic energy into rest energy. In 1974, SLAC National Accelerator Laboratory accelerated electrons and positrons up to relativistic velocities, so that their relativistic energy is significantly increased to about 1500 MeV each. When those particles collide, other particles such as the J/ψ meson of rest energy of about 3000 MeV were produced.
Much higher energies were employed at the Large Electron–Positron Collider in 1989, where electrons and positrons were accelerated up to 45 GeV each, in order to produce W and Z bosons of rest energies between 80 and 91 GeV. Later, the energies were considerably increased to 200 GeV to generate pairs of W bosons.
Such bosons were also measured using proton-antiproton annihilation. The combined rest energy of those particles amounts to approximately 0.938 GeV each. The Super Proton Synchrotron accelerated those particle up to relativistic velocities and energies of approximately 270 GeV each, so that the center of mass energy at the collision reaches 540 GeV. Thereby, quarks and antiquarks gained the necessary energy and momentum to annihilate into W and Z bosons.
Many other experiments involving the creation of a considerable amount of different particles at relativistic velocities have been conducted in hadron colliders such as Tevatron, the Relativistic Heavy Ion Collider, and most recently the Large Hadron Collider in the course of searching for the Higgs boson.