Earth's mantle


The Earth's mantle is a layer of silicate rock between the crust and the outer core. It has a mass of 4.01 × 1024 kg and thus makes up 67% of the mass of the Earth. It has a thickness of making up about 84% of Earth's volume. It is predominantly solid but in geological time it behaves as a viscous fluid. Partial melting of the mantle at mid-ocean ridges produces oceanic crust, and partial melting of the mantle at subduction zones produces continental crust.

Structure

Rheology

The Earth's mantle is divided into two major rheological layers: the rigid lithosphere comprising the uppermost mantle, and the more viscous asthenosphere, separated by the lithosphere-asthenosphere boundary. Lithosphere underlying ocean crust has a thickness of around 100 km, whereas lithosphere underlying continental crust generally has a thickness of 150-200 km. The lithosphere and overlying crust make up tectonic plates, which move over the asthenosphere.
The Earth's mantle is divided into three major layers defined by sudden changes in seismic velocity:
The lower ~200 km of the lower mantle constitutes the D" layer, a region with anomalous seismic properties. This region also contains LLSVPs and ULVZs.

Mineralogical structure

The top of the mantle is defined by a sudden increase in seismic velocity, which was first noted by Andrija Mohorovičić in 1909; this boundary is now referred to as the Mohorovičić discontinuity or "Moho".
The upper mantle is dominantly peridotite, composed primarily of variable proportions of the minerals olivine, clinopyroxene, orthopyroxene, and an aluminous phase. The aluminous phase is plagioclase in the uppermost mantle, then spinel, and then garnet below ~100 km. Gradually through the upper mantle, pyroxenes become less stable and transform into majoritic garnet.
At the top of the transition zone, olivine undergoes isochemical phase transitions to wadsleyite and ringwoodite. Unlike nominally anhydrous olivine, these high-pressure olivine polymorphs have a large capacity to store water in their crystal structure. This has led to the hypothesis that the transition zone may host a large quantity of water. At the base of the transition zone, ringwoodite decomposes into bridgmanite, and ferropericlase. Garnet also becomes unstable at or slightly below the base of the transition zone.
The lower mantle is composed primarily of bridgmanite and ferropericlase, with minor amounts of calcium perovskite, calcium-ferrite structured oxide, and stishovite. In the lowermost ~200 km of the mantle, bridgmanite isochemically transforms into post-perovskite.

Composition

The chemical composition of the mantle is difficult to determine with a high degree of certainty because it is largely inaccessible. Rare exposures of mantle rocks occur in ophiolites, where sections of oceanic lithosphere have been obducted onto a continent. Mantle rocks are also sampled as xenoliths within basalts or kimberlites.
CompoundMass percent
SiO244.71
Al2O33.98
FeO8.18
MnO0.13
MgO38.73
CaO3.17
Na2O0.13
Cr2O30.57
TiO20.13
NiO0.24
K2O0.006
P2O50.019

Most estimates of the mantle composition are based on rocks that sample only the uppermost mantle. There is debate as to whether the rest of the mantle, especially the lower mantle, has the same bulk composition. The mantle's composition has changed through the Earth's history due to the extraction of magma that solidified to form oceanic crust and continental crust.

Temperature and pressure

In the mantle, temperatures range from approximately at the upper boundary with the crust to approximately at the core-mantle boundary. The geothermal gradient of the mantle increases rapidly in the thermal boundary layers at the top and bottom of the mantle, and increases gradually through the interior of the mantle. Although the higher temperatures far exceed the melting points of the mantle rocks at the surface, the mantle is almost exclusively solid. The enormous lithostatic pressure exerted on the mantle prevents melting, because the temperature at which melting begins increases with pressure.
The pressure in the mantle increases from a few kbar at the Moho to 1390 kbar at the core-mantle boundary.

Movement

Because of the temperature difference between the Earth's surface and outer core and the ability of the crystalline rocks at high pressure and temperature to undergo slow, creeping, viscous-like deformation over millions of years, there is a convective material circulation in the mantle. Hot material upwells, while cooler material sinks downward. Downward motion of material occurs at convergent plate boundaries called subduction zones. Locations on the surface that lie over plumes are predicted to have high elevation and to exhibit hot spot volcanism. The volcanism often attributed to deep mantle plumes is alternatively explained by passive extension of the crust, permitting magma to leak to the surface.
The convection of the Earth's mantle is a chaotic process, which is thought to be an integral part of the motion of plates. Plate motion should not be confused with continental drift which applies purely to the movement of the crustal components of the continents. The movements of the lithosphere and the underlying mantle are coupled since descending lithosphere is an essential component of convection in the mantle. The observed continental drift is a complicated relationship between the forces causing oceanic lithosphere to sink and the movements within Earth's mantle.
Although there is a tendency to larger viscosity at greater depth, this relation is far from linear and shows layers with dramatically decreased viscosity, in particular in the upper mantle and at the boundary with the core. The mantle within about above the core–mantle boundary appears to have distinctly different seismic properties than the mantle at slightly shallower depths; this unusual mantle region just above the core is called D″, a nomenclature introduced over 50 years ago by the geophysicist Keith Bullen. D″ may consist of material from subducted slabs that descended and came to rest at the core–mantle boundary and/or from a new mineral polymorph discovered in perovskite called post-perovskite.
Earthquakes at shallow depths are a result of strike-slip faulting; however, below about the hot, high pressure conditions ought to inhibit further seismicity. The mantle is considered to be viscous and incapable of brittle faulting. However, in subduction zones, earthquakes are observed down to. A number of mechanisms have been proposed to explain this phenomenon, including dehydration, thermal runaway, and phase change.
The geothermal gradient can be lowered where cool material from the surface sinks downward, increasing the strength of the surrounding mantle, and allowing earthquakes to occur down to a depth of and.
The pressure at the bottom of the mantle is ~136 GPa. Pressure increases as depth increases, since the material beneath has to support the weight of all the material above it. The entire mantle, however, is thought to deform like a fluid on long timescales, with permanent plastic deformation accommodated by the movement of point, line, and/or planar defects through the solid crystals composing the mantle. Estimates for the viscosity of the upper mantle range between 1019 and 1024 Pa·s, depending on depth, temperature, composition, state of stress, and numerous other factors. Thus, the upper mantle can only flow very slowly. However, when large forces are applied to the uppermost mantle it can become weaker, and this effect is thought to be important in allowing the formation of tectonic plate boundaries.

Exploration

Exploration of the mantle is generally conducted at the seabed rather than on land because of the relative thinness of the oceanic crust as compared to the significantly thicker continental crust.
The first attempt at mantle exploration, known as Project Mohole, was abandoned in 1966 after repeated failures and cost over-runs. The deepest penetration was approximately. In 2005 an oceanic borehole reached below the sea floor from the ocean drilling vessel JOIDES Resolution.
More successful was the Deep Sea Drilling Project that operated from 1968 to 1983. Coordinated by the Scripps Institution of Oceanography at the University of California, San Diego, DSDP provided crucial data to support the seafloor spreading hypothesis and helped to prove the theory of plate tectonics. Glomar Challenger conducted the drilling operations. DSDP was the first of three international scientific ocean drilling programs that have operated over more than 40 years. Scientific planning was conducted under the auspices of the Joint Oceanographic Institutions for Deep Earth Sampling, whose advisory group consisted of 250 distinguished scientists from academic institutions, government agencies, and private industry from all over the world. The Ocean Drilling Program continued exploration from 1985 to 2003 when it was replaced by the Integrated Ocean Drilling Program.
On 5 March 2007, a team of scientists on board the RRS James Cook embarked on a voyage to an area of the Atlantic seafloor where the mantle lies exposed without any crust covering, midway between the Cape Verde Islands and the Caribbean Sea. The exposed site lies approximately three kilometres beneath the ocean surface and covers thousands of square kilometres.
A relatively difficult attempt to retrieve samples from the Earth's mantle was scheduled for later in 2007. The Chikyu Hakken mission attempted to use the Japanese vessel Chikyū to drill up to below the seabed. This is nearly three times as deep as preceding oceanic drillings.
A novel method of exploring the uppermost few hundred kilometres of the Earth was proposed in 2005, consisting of a small, dense, heat-generating probe which melts its way down through the crust and mantle while its position and progress are tracked by acoustic signals generated in the rocks. The probe consists of an outer sphere of tungsten about one metre in diameter with a cobalt-60 interior acting as a radioactive heat source. It was calculated that such a probe will reach the oceanic Moho in less than 6 months and attain minimum depths of well over in a few decades beneath both oceanic and continental lithosphere.
Exploration can also be aided through computer simulations of the evolution of the mantle. In 2009, a supercomputer application provided new insight into the distribution of mineral deposits, especially isotopes of iron, from when the mantle developed 4.5 billion years ago.